Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Experimental Research on Convective Condensation Heat Transfer for Wet Flue Gas Outside Horizontal Tube

Effects of Condensation of Water Vapor of Wet Flue Gas on Convection Heat Transfer in Vertical Tubes

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Investigation of the forced-convection heat-transfer in the boiler flue-gas heat recovery units employing the real-time measured database

Optimization of Flue Gas Turbulent Heat Transfer with Condensation in A Tube

Experimental Study of the Condensation Heat Transfer Performance of Flue Gases in a Heating-and-power Cogeneration System

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental Study Of Condensation Flow Inside Horizontal Smooth, Herringbone And Three Enhanced Surface Tubes

Experimental Study on Condensation in the Outer Annular Region Outside Horizontal Enhanced Tubes

A numerical study on convective condensation of flue gas in tubular heat exchangers

Numerical Investigation of Air-Steam Condensation in a Vertically Enhanced Tube with Concave and Convex Surfaces

Heat transfer performance of direct-contact flue-gas condensation heat exchanger

Experimental research on falling film flow and heat transfer characteristics outside the vertical tube

Experimental Study Of Natural Gas Combustion Flue Gas Waste Heat Recovery System Based On Direct Contact Heat Transfer And Absorption Heat Pump

Flue gas-water direct-contact heat transfer performances

Heat transfer characteristics in vertical tube condensers: Experimental investigation and numerical validation

Optimization of Flue Gas Convective Heat Transfer with Condensation in a Rectangular Channel

Condensation Heat Transfer Characteristics On The Outside Of Horizontal Smooth, Herringbone And Enhanced Surface 1eht Tubes

Experimental research on non-azeotropic immiscible binary mixed vapors condensation mode and heat mass transfer characteristics under natural convection

Experiment on Forced Convection-Condensation Heat Transfer Characteristics Based on Finned Plate Configuration

Experimental investigation on convective condensation heat transfer in horizontal 4mm diameter coated tube