Abstract:In some circumstances, hybrid polymer microfluidic chips composed of both elastic, gas-permeable polydimethylsiloxane (PDMS) and rigid plastics are needed. However, it is quite difficult to bond PDMS irreversibly to plastics such as polystyrene (PS). In this article, a facile method for irreversible bonding of PDMS to PS was proposed based on UV/O-3-assisted surface modification in combination of surface silanization. Firstly, a PS sheet was exposed to UV/O-3 to produce oxygen-containing polar moieties, such as hydroxyl and carboxylic acid, on its surface. Secondly, the UV/O-3 treated PS sheet was silanized with (3-aminopropyl)triethoxysilane (APTES) via the reaction between the oxygen-containing polar moieties on the PS surface and the molecules of APTES. Thirdly, the silanized-PS sheet and the PDMS substrate with micro channel network were treated with UV/O-3 again to generate silanol moieties on both surfaces. Finally, the UV/O-3 treated PDMS was immediately brought intimate contact with the UV/O-3 treated silanized-PS, and irreversible bonding of PDMS with PS occurred after putting the PDMS-PS complex at room temperature for 1 h through the condensation reaction between silanol moieties. Contact angle measurement, X-ray photoelectron spectroscopy, total reflection Fourier transformation infrared spectrometer were applied to characterize the surface chemistry of the PS during the UV/O-3 treatment and silanization. The hybrid PDMS-PS microfludic chips prepared with the established method can bear a gas pressure higher than 0.5 MPa and a water stream at a flow rate higher than 170 mu L/min (the test channels were 2.5 cm in the length, 50 mu m in the width, 200 mu m in the depth). A hybrid PDMS-PS microfluidic chip composed of gas-permeable PDMS substrate with channel network and excellently biocompatible PS cover sheet was fabricated for cell culture. The experimental results showed that HeLa cells cultured in the hybrid PDMS-PS microchip grew much better than those cultured in the full PS microchip, and slightly better than those in the full PDMS microchip.

Reaction of Porous Silicon with Both End-Functionalized Organic Compounds Bearing α-Bromo and ω-Carboxy Groups for Immobilization of Biomolecules

Grafting Organic and Biomolecules on H-Terminated Porous Silicon from a Diazirine

Functionalization of Hydrogen-Terminated Silicon Via Surface-Initiated Atom-Transfer Radical Polymerization and Derivatization of the Polymer Brushes

Preparation of Organic Monolayers with Azide on Porous Silicon Via Si–N Bonds

Biofunctionalisation of Porous Silicon (ps) Surfaces by Using Homobifunctional Cross-Linkers

A Simple Method for Covalent Immobilization of Proteins on Porous Silicon Surfaces

Functionalization of Hydrogen-Terminated Si(100) Substrate by Surface-Initiated Raft Polymerization of 4-Vinylbenzyl Chloride and Subsequent Derivatization for Photoinduced Metallization

Macroporous silicon templated from silicon nanocrystallite and functionalized SiH reactive group for grafting organic monolayer

Study of PVDF porous membranes blending with organic-inorganic hybrid nanoparticles via surface zwitterionicalization

Synthesis of mesoporous silica material with hydrophobic external surface and hydrophilic internal surface for protein adsorption

Hydrolysis and silanization of the hydrosilicon surface of freshly prepared porous silicon by an amine catalytic reaction

Biological Functionalization and Patterning of Porous Silicon Prepared by Pt-assisted Chemical Etching

Functionalization of Polydimethylsiloxane with Diazirine-Based Linkers for Covalent Protein Immobilization

Active Protein-Functionalized Poly(Poly(Ethylene Glycol) Monomethacrylate)-Si(100) Hybrids from Surface-Initiated Atom Transfer Radical Polymerization for Potential Biological Applications

An Approach for Irreversible Bonding of PDMS-PS Hybrid Microfluidic Chips at Room Temperature

In Situ Silanization Reaction on the Surface of Freshly Prepared Porous Silicon

Solution-phase Surface Modification in Intact Poly(dimethylsiloxane) Microfluidic Channels.

Stability Improvement of Porous Silicon Surface Structures by Grafting Polydimethylsiloxane Polymer Monolayers

Preparation and Characterization of Porous Silicon-Supported Bilayers Lipid Membranes

Vapor-Phase Silanization of Oxidized Porous Silicon for Stabilizing Composition and Photoluminescence

Preparation of Polystyrene/Sio2 Composite Nanoparticles Bearing Sulfonic Groups on the Surface Via Emulsion Copolymerization Using A Polymerizable Emulsifier