Abstract:To stop global warming well below 2°C, a rapid decarbonization of our economy, including the industrial sector is required—reaching net-zero GHG emissions in 2050. CO 2 mineralization processes, capturing CO 2 from industrial point sources and trapping it as carbonate minerals, have the potential to store climate-relevant amounts of CO 2 . To get there, the potential processes have to be designed and developed, with the help of a process model that can support the process scale-up and optimization. In this work, a process model describing a gas-liquid-solid continuous cristallizer for CO 2 absorption into an aqueous ammonium nitrate solution and CaCO 3 precipitation has been developed. It consists of the relevant material balances, of a speciation model, and a population balance equation. While several of the model parameters can be obtained from the literature, a few have been estimated by fitting a comprehensive set of experimental data presented earlier. In particular, the process quantities used for parameter estimation are the CO 2 mass transfer rate, the calcium carbonate crystallization rate, and the average particle size of the CaCO 3 product crystals. The accuracy of the model, particularly in reproducing mass transfer rates and average particle sizes, has been assessed. Interestingly, it has been shown that the dominating mechanism for crystal formation is primary rather than secondary nucleation. The validated model has been used to explore the effect of the different operating conditions on various key performance indicators so as to gain a deeper insight into the process performance and potential. It has been shown that the CO 2 absorption efficiency is mainly affected by the feed stoichiometry and the gas feed rate, whereas the CO 2 capture and precipitation efficiency are controlled by the liquid phase composition and the residence time; increasing the calcium concentration in the feed is obviously one way to improve the efficiency. Moreover, we could show that the particle size tends to increase with calcium concentration and to decrease with liquid feed rate and supersaturation of the solution.

Operating Parameters Optimization of Continual Carbonation Decomposition

Application of advanced process control to carbonation columns in manufacture of soda

Scalable Multi-Objective Optimization of Industrial Purified Terephthalic Acid (PTA) Oxidation Process

Multi-objective Optimization of Operating Parameters Based on Neural Network and Genetic Algorithm in the Blast Furnace

Optimization of Calcium Carbide Residue Utilization for Producing High‐quality Calcium Carbonate

A Multi-Objective Optimization Model Based on Long Short-Term Memory and Non-Dominated Sorting Genetic Algorithm II

NCO-GMC Cascade Control Algorithm Based On-Line Optimization on Fed Batch Fermentation

Crow Search Algorithm for Modelling an Anaerobic Digestion Process: Algorithm Parameter Influence

Artificial Neural Network-Genetic Algorithm-Based Optimization of Aerobic Composting Process Parameters of Ganoderma lucidum Residue

Design Space Calculation and Continuous Improvement Considering a Noise Parameter: A Case Study of Ethanol Precipitation Process Optimization for Carthami Flos Extract

Optimization of the A2/O technological parameters based on GA-ANN model

CFD-aided Optimization of the Decomposition Kinetics of Cement Raw Meals under High CO2 Concentrations

Optimization of preparation of calcium carbonate from continuous crystallization process of ammonium carbonate and conversion of calcium sulfate by response surface methodology

RSM‐, ANN‐, and GA‐Based Process Optimization for Acid Centrifugation Treatment of Cane Molasses Toward Mitigating Calcium Oxide Fouling in Ethanol Plant Heat Exchanger

Kinetic, Artificial Neural Network and Statistical Modeling to Optimize the Parameters of the Air Flotation Process to Remove Latex Suspended Solids in Abs Wastewater

Quantitative Assessment and Multi-Objective Optimization of Supercritical CO2 Cycles with Multiple Operating Parameters

Optimization for Operating Conditions for Synthetic Ammonia System in Medium and Small Scale Nitrogen Fertilizer Plant

Minimum Entropy Generation Rate and Maximum Yield Optimization of Sulfuric Acid Decomposition Process Using NSGA-II

Quantitative assessment and multi-objective optimization of supercritical CO 2 cycles with multiple operating parameters

Modeling of a Continuous Carbonation Reactor for CaCO3 Precipitation

CFD-aided optimization of the decomposition kinetics of cement raw meals under high CO 2 concentrations