Abstract:During the measurement of multiphase flow in low yield oil wells, the liquid volume will vary with the operating characteristics of the pumping unit. Using the pulsating characteristics of the up and down strokes of a pumping unit, the flow rate is measured when there is a flow rate on the up stroke, and the water content is measured when the fluid is stationary on the down stroke. In this paper, the heat transfer method is used to measure the water content of the oil water mixture during the down stroke process. At this time, the water content can be expressed as the instantaneous water content of the oil well. Firstly, the feasibility of measuring water content using heat transfer method is demonstrated theoretically, and then the temperature change of the heating probe PT300 is simulated. Finally, the actual temperature of PT300 is measured experimentally. Comparing the experimental value with the simulation value, the calculated measurement error is within 1.27 %, which indicates that the heat transfer method is feasible for measuring water content. Using the same single sensor to measure oil water two-phase flow using the pulsation characteristics of the up and down strokes of a pumping unit is a major innovation in this paper. And lays a foundation for the detection of multiphase flow using heat transfer methods. The successful implementation of the text heat transfer method for measuring water content has broken the previous situation of multiple sensor detection, simplified the structure of multiphase flow instruments, and extended the life of the instrument.

Water Content of Crude Oil Measurement Based on Sensor Fusion Technology

Measurement of Crude Oil Water Content Based on Cross-Correlation Method

Research on Measurement Method of Oil-Water Interface Based on Oscillation Frequency

The information fusion method in the system of water content measurement in heavy oil

The latest development of multi-interface detection sensor technology for crude oil

Research on COD Soft Measurement Technology Based on Multi-Parameter Coupling Analysis Method

Study of a novel surface acoustic wave liquid detection system

A New Sensor for the Void Fraction Measurement of Gas-Liquid Two-Phase Flow

Research on water content measurement method based on heat transfer method

An Impedance Sensor for Distinguishing Multi-Contaminants in Hydraulic Oil of Offshore Machinery

Detection of Oil-Water Emulsions in Oil Samples Using Low-Cost UHF RFID Sensors

Measurement of Water Content in Heavy Oil with Cavity Resonator

Measurement system of ultra‐low moisture content in oil based on the microwave transmission method

Water Content Monitoring in Water-in-Oil Emulsions Using a Piezoceramic Sensor

Distilling Determination of Water Content in Hydraulic Oil with a ZnO/glass Surface Acoustic Wave Device

Automatic Determination of Liquid's Interface in Crude Oil Tank using Capacitive Sensing Techniques

Study on the Portable Oil-Water Interface Detector

Submersible High Sensitivity Microwave Sensor for Edible Oil Detection and Quality Analysis

Automatic Measurement of the Concentration of Oil and Water Mixture Using Heterodyne Frequency Method

Research and Application of Automatic Crude Oil Metering System

Research of Water Content Measurement Based on Microwave Transmission