Developing microfluidic purification techniques for biodiesel production from recycled grease trap waste
Thanh K.N. Pham,Trang T. Nguyen,Nguyen Van Duc Long,Nam Nghiep Tran,Muhammad Yousaf Arshad,Mohammad Mohsen Sarafraz,Volker Hessel
DOI: https://doi.org/10.1039/d4se00567h
IF: 6.813
2024-11-02
Sustainable Energy & Fuels
Abstract:This study aimed to investigate the desulphurisation process of model biodiesel containing thiophene (Th) using 5 different solvents (sulfolane, ionic liquids (ILs) - [BMIM]AlCl4, [BMIM]MSA, and deep eutectic solvents (DESs) - choline chloride (ChCl):Phenol (Ph), ChCl:Polyethylene glycol (PEG)). The investigation focused on evaluating the impact of solvent-to-fuel (S:F) ratio, mixture flow rate, and temperature to optimize the process using a central composite design. The results indicated that the optimal condition for desulfurization was achieved by employing ChCl:PEG at a high S:F ratio of 2:1, a low mixture flow rate of 1.55 mL/min, and a temperature of 30°C, resulting in a removal efficiency of 65.81%.. To meet the economical requirements, the desirability function suggested operating the system at S:F ratio of 1.85, mixture flowrate of 1.77 ml/min, and temperature of 25oC, with the predicted yield of 55.38%. The conditions were experimentally checked, resulting in 44% of removal for a single stage and 80% of removal for 5 stages. However, the chosen purification technique would increase the total operational cost by $12.77 per litre. This financial barrier can be overcome by further considering the ability to regenerate solvent and the use of different configurations of the microfluidic device for higher efficiency.
materials science, multidisciplinary,chemistry, physical,energy & fuels