Abstract:Because they have the potential for ultra low NOx emissions and high efficiency, Homogeneous Charge Compression Ignition (HCCI) engines have the potential to develop a significant niche. However, a narrow operating range, (bracketed by severe knock and misfire problems), presents a formidable obstacle to developing usable HCCI combustion systems. HCCI combustion is influenced by a complex array of operating variables including fuel octane quality, intake preheating temperature, compression ratio, equivalence ratio, exhaust gas recirculation and engine component temperature. These variables affect the two critical combustion parameters: ignition timing and combustion duration. If these two parameters can be controlled by appropriate settings of the operating variables, a good HCCI combustion scheme could be achieved. Therefore, the theoretical prediction of these two combustion parameters as a function of the key operating variables is necessary for development of HCCI combustion. This paper describes a stand-alone, single-zone and multi-zone combustion model which have been developed for the specific purpose of investigating HCCI combustion control. In the multi-zone model, temperature and composition in each zone were adjusted in order to study the effect of in-homogeneity which is critical to understanding ignition timing and combustion duration in real HCCI engines. The models simulated HCCI combustion using two fuels: hydrogen, (11 species, 23 reactions- from CHEMKIN library), and natural gas, (53 species, 325 reactions- from GRI mech). The capabilities of the two models to predict ignition timing, combustion duration and peak pressure were verified against experimental and simulation results of Fiveland et al [2, 11]. The models were then used to study the effect of different in-homogeneity levels of equivalence ratio, intake temperature and residual fraction. The single zone model could only predict ignition timing while the multi-zone model shows the capability to mimic realistic HCCI combustion phenomena. The study showed that some degree of in-homogeneity is critical to predicting performance of the homogeneous charge compression ignition engine. Further, stratification of equivalence ratio was relatively ineffective at changing combustion while stratification of mixture temperature was very effective. Stratification of the residual fraction proved to be the most promising method of controlling combustion parameters and the mechanism was primarily thermal.

Reduced Chemical Kinetic Model of N-Heptane for HCCI Combustion

Reduced Kinetic Mechanism of N‐heptane Oxidation in Modeling Polycyclic Aromatic Hydrocarbon Formation in Diesel Combustion

Reduced chemical kinetics mechanism for modelling of n-Heptane/syngas combustion with NOx formation in a micro-pilot ignited dual fuel engine

Development of a reduced chemical mechanism for ammonia/ n -heptane blends

Reduced Kinetic Mechanism of N -Heptane Oxidation in Modeling Polycyclic Aromatic Hydrocarbon Formation in Opposed-Flow Diffusion Flames

Reduced kinetics of NH 3 /n-heptane: Model analysis and a new small mechanism for engine applications

Novel Method for Quantitative Assessment of Reduced Chemical Mechanisms Based on the Inherent Similarity Evaluation: Case Study of n -Heptane

A Reduced Combustion Kinetic Model for the Methanol-Gasoline Blended Fuels on SI Engines

Chemical Kinetic Model for Ignition of Three-Component Fuel Comprising Iso-Octane/N-Heptane/Ethanol

Study of HCCI Combustion Characteristics with High RON Fuel

Two-zone Chemical Kinetics Modeling of a Gasoline HCCI Engine

Modeling of HCCI combustion: From 0D to 3D

Development of a reduced n-heptane/toluene/tetrahydrofuran mechanism for dual-fuel engine combustion prediction

A Stand-Alone Multi-Zone Model for Combustion in HCCI Engines

Reduction of chemical mechanism and kinetics analysis for ignition of RP-3 aviation kerosene in partially catalyzed hydrogen peroxide

Experiment and Chemical Kinetics Analysis of Active Atmosphere with Different Fuels in HCCI Combustion

Construction of a Small-Sized Simplified Chemical Kinetics Model for the Simulation of n-Propylcyclohexane Combustion Properties

Reduced Kinetic Model for Complex Turbulent n-Heptane Flame Simulations

Strategies for mechanism reduction for large hydrocarbons: n-heptane

Direct Modeling of Auto-Ignition and Flame Propagation of N-heptane-Air Mixtures at HCCI Conditions by Using Dynamic Multi-Timescale Method

Compact Combustion Mechanisms of Typical n-Alkanes Developed by the Minimized Reaction Network Method