Experimental Study on Basic Characteristics and Ore-blending Optimization of Xingtai Steel Raw Materials for Sintering
Kai ZHAO,Jie LI,Yuzhu ZHANG,Weixing LIU,Yue LONG,YuJiang LIU
DOI: https://doi.org/10.3969/j.issn.0253-6099.2016.04.023
2016-01-01
Abstract:The basic characteristics of 7 kinds of iron ore powders for Xingtai Steel Sintering Plant were studied systematically with micro sintering experiment device. The results show that 7 kinds of powders are quite different in assimilation performance, flowability, cohesiveness, calcium ferrite formation features and water absorption. The sundries exhibit the best assimilation performance at the temperature of 1 200 ℃, while the mixed ore has the best flowability, with a flowability index at 1.69. The binding phase of low silica powder shows the highest strength of 4 548 N, and the sundries have the highest water absorption of 36. 32%. Experiments on ore?blending optimization for sintering process were carried out on this basis. By reducing Australia′s ore ratio in the mixed ore and increasing the ratio of local alkali fine powder, the basic characteristics of the mixture are improved, with the assimilation temperature raised by 20 ℃, the flowability index falling to 1.27, the strength of the binding phase increased by 281 N and water absorption reduced by 1 percentage point. The sinter pot test shows that the vertical sintering speed is improved while the final product yield, drum strength, as well as low?temperature reduction degradation index are all increased by 4.5 percentage points, 2 percentage points, and 3 percentage points, respectively, with both reduction property and load softening property improved. These research results can be taken as the theoretical guidance for iron?ore blending optimization and improvement of sintered ore quality in Xingtai Steel Sintering Plant.