In Vitro Evaluation of the Adhesive Characteristics of Microbubbles with Sialyl LewisX Targeted to Fc Segment of P-selectin

LI Ying,WANG Xiujun,LI Junhua,YANG Li,LI Meiyu,XIAO Yunbin,LIAO Wangjun,BIN Jianping
DOI: https://doi.org/10.3969/j.issn.1005-5185.2012.07.015
2012-01-01
Abstract:Purpose To evaluate the adhesive characteristics of microbubbles with sialyl Lewis X(MB-SLex) targeted to Fc segment of P-selectin(PSFc) and compare with those of microbubbles with anti-ICAM-1 monoclone antibody(MBICAM) to ICAM-1 antigen in vitro.Materials and Methods MB-SLex,MB-ICAM and microbubbles with isotype IgG1(MB-C) were prepared.The attachment and detachment of MB-SLex to PSFc and MB-ICAM to ICAM-1 antigen in the shear stress of 0.5 dyn/cm 2 and 4.0 dyn/cm 2 were assessed in a parallel-plate flow chamber,meanwhile MB-C was served as a control.Results The attachment rate of MB-SLex targeted to PSFc in the shear stress of 0.5 dyn/cm 2 was similar to that of MB-ICAM targeted to ICAM-1 antigen.Only at the condition of 4.0 dyn/cm 2,the attachment rate was significantly higher in the MB-Slex group than the MB-ICAM group(P0.05).However,the rolling number of MB-SLex on PSFc was greater than that of MBICAM on ICAM-1 antigen(P0.05) in both 0.5 and 4.0 dyn/cm 2.As compared with MB-SLex and MB-ICAM,the attachment and rolling number of MB-C targeted to ICAM-1 antigen were very limited(P 0.05).The shear stress of half detachment in MB-SLex was smaller than that in MB-ICAM at the detaching test(P 0.05).Conclusion MB-SLex targeted to PSFc is quick but not firm at high shear stress.sialyl Lewis X can be used as adhesion-inducing molecules in the construction of sitetargeted microbubbles,which can have sufficient and specific adhesion efficacy in high-shear flow.
What problem does this paper attempt to address?