Abstract:Intersections and discontinuities commonly arise in surface modeling and cause problems in downstream operations. Local geometry repair, such as cover holes or replace bad surfaces by adding new surface patches for dealing with inconsistencies among the confluent region, where multiple surfaces meet, is a common technique used in CAD model repair and reverse engineering. However, local geometry repair destroys the topology of original CAD model and increases the number of surface patches needed for freeform surface shape modeling. Consequently, a topology recovery technique dealing with complex freeform surface model after local geometry repair is proposed. Firstly, construct the curve network which determine the geometry and topology properties of recovery freeform surface model; secondly, apply freeform surface fitting method to create B-spline surface patches to recover the topology of trimmed ones. Corresponding to the two levels of enforcing boundary conditions on a B-spline surface, two solution schemes are presented respectively. In the first solution scheme, non-constrained B-spline surface fitting method is utilized to piecewise recover trimmed confluent surface patches and then employs global beautification technique to smoothly stitch the recovery surface patches. In the other solution scheme, constrained B-spline surface fitting technique based on discretization of boundary conditions is directly applied to recover topology of surface model after local geometry repair while achieving G 1 continuity simultaneously. The presented two different schemes are applied to the consistent surface model, which consists of five trimmed confluent surface patches and a local consistent surface patch, and a machine cover model, respectively. The application results show that our topology recovery technique meets shape-preserving and G 1 continuity requirements in reverse engineering. This research converts the problem of topology recovery for consistent surface model to the problem of constructing G 1 patches from a given curve network, and provides a new idea to model repairing study.

Redesign of a Conformal Boundary Recovery Algorithm for 3D Delaunay Triangulation

Three-dimensional Constrained Boundary Recovery with an Enhanced Steiner Point Suppression Procedure

Boundary recovery after 3D Delaunay tetrahedralization without adding extra nodes

3D boundary recovery by constrained Delaunay tetrahedralization

Improved Boundary Constrained Tetrahedral Mesh Generation by Shell Transformation

Booleans of triangulated solids by a boundary conforming tetrahedral mesh generation approach

An Improved Local Remeshing Algorithm for Moving Boundary Problems

Boundary Recovery For Delaunay Tetrahedral Meshes Using Local Topological Transformations

Unstructured tetrahedral mesh generation for complex configurations

SPR — A New Method for Mesh Improvement and Boundary Recovery

Improvements In The Reliability And Element Quality Of Parallel Tetrahedral Mesh Generation

Recursive Algorithms for 3D Triangulation Decomposition and 2D Parameterization

Unstructured Mesh Generation and Its Parallelization

Boundary-conforming Tetrahedral Mesh Generation for Arbitrary Polyhedron

Trimming self-intersections in swept volume solid modeling

An Improved Parallel Computation Method for Delaunay Triangulation

Triangular Mesh Generation on Free-Form Surfaces Based on Bubble Dynamics Simulation

Geometry-based adaptive mesh generation for continuous and discrete parametric surfaces

Three-dimensional Unstructured Mesh Generation: Part 1. Fundamental Aspects of Triangulation and Point Creation

Topology Recovery Technique for Complex Freeform Surface Model after Local Geometry Repair

Research on 3D Constrained Delaunay Triangulation