Abstract:Intersections and discontinuities commonly arise in surface modeling and cause problems in downstream operations. Local geometry repair, such as cover holes or replace bad surfaces by adding new surface patches for dealing with inconsistencies among the confluent region, where multiple surfaces meet, is a common technique used in CAD model repair and reverse engineering. However, local geometry repair destroys the topology of original CAD model and increases the number of surface patches needed for freeform surface shape modeling. Consequently, a topology recovery technique dealing with complex freeform surface model after local geometry repair is proposed. Firstly, construct the curve network which determine the geometry and topology properties of recovery freeform surface model; secondly, apply freeform surface fitting method to create B-spline surface patches to recover the topology of trimmed ones. Corresponding to the two levels of enforcing boundary conditions on a B-spline surface, two solution schemes are presented respectively. In the first solution scheme, non-constrained B-spline surface fitting method is utilized to piecewise recover trimmed confluent surface patches and then employs global beautification technique to smoothly stitch the recovery surface patches. In the other solution scheme, constrained B-spline surface fitting technique based on discretization of boundary conditions is directly applied to recover topology of surface model after local geometry repair while achieving G 1 continuity simultaneously. The presented two different schemes are applied to the consistent surface model, which consists of five trimmed confluent surface patches and a local consistent surface patch, and a machine cover model, respectively. The application results show that our topology recovery technique meets shape-preserving and G 1 continuity requirements in reverse engineering. This research converts the problem of topology recovery for consistent surface model to the problem of constructing G 1 patches from a given curve network, and provides a new idea to model repairing study.

Three-dimensional Constrained Boundary Recovery with an Enhanced Steiner Point Suppression Procedure

Redesign of a Conformal Boundary Recovery Algorithm for 3D Delaunay Triangulation

Improved Boundary Constrained Tetrahedral Mesh Generation by Shell Transformation

3D boundary recovery by constrained Delaunay tetrahedralization

Boundary recovery after 3D Delaunay tetrahedralization without adding extra nodes

SPR — A New Method for Mesh Improvement and Boundary Recovery

Unstructured tetrahedral mesh generation for complex configurations

Boundary Recovery For Delaunay Tetrahedral Meshes Using Local Topological Transformations

Boundary-conforming Tetrahedral Mesh Generation for Arbitrary Polyhedron

An Improved Local Remeshing Algorithm for Moving Boundary Problems

Booleans of triangulated solids by a boundary conforming tetrahedral mesh generation approach

Geometry-based adaptive mesh generation for continuous and discrete parametric surfaces

Topology Recovery Technique for Complex Freeform Surface Model after Local Geometry Repair

Unstructured Mesh Generation and Its Parallelization

Trimming self-intersections in swept volume solid modeling

Heuristic Region Growing Mesh Reconstruction Algorithm

Automatic hexahedral mesh generation for many-to-one sweep volumes

Improvements In The Reliability And Element Quality Of Parallel Tetrahedral Mesh Generation

Surface Extraction and Boundary Detection Based on DBSCAN Clustering in 3D Point Clouds

A Novel Type of Boundary Extraction Method and Its Statistical Improvement for Unorganized Point Clouds Based on Concurrent Delaunay Triangular Meshes

An Improved Parallel Computation Method for Delaunay Triangulation