Abstract:NHR-200-II is a small integrated pressurized water reactor with 200 MW core thermal power. The core heat is transferred to two independent intermediate circuits via fourteen in-vessel primary heat exchangers (PHE), and the heat in the intermediate circuits is transferred to feedwater by two steam generators (SG) in the two intermediate circuits respectively. A passive residual heat removal (PRHR) branch is connected to each intermediate circuit to remove core decay heat under postulated accidents. During normal operation, PRHR branches are isolated by valves while SG branches in intermediate circuits are open. The valves in PRHR branches will be opened and the isolation valves of SG branches will be closed during decay heat removal scenarios. The decay heat removal capacity of NHR-200-II PRHRS could be seriously deteriorated once the isolation valves for SG branches fail to close, which was confirmed in a scaled integral test loop previously. Current understanding of PRHRS’s thermal-hydraulic characteristics with possible isolation failure in SG branches is limited. In this paper, the NHR-200-II PRHRS is modeled with RELAP5 considering the case of success and fail to isolate SG branches. A series of numerical simulations are carried out to study the impact of various parameters, such as the initial temperature, the size of the intermediate circuits’ header, and the initial flow direction in the intermediate circuits. Oscillatory flow is found when SG branches fail to be isolated under certain parameters combinations. An improved PRHRS design is purposed to eliminate possible flow oscillations, and the purposed improved design are tested by numerical simulations.

The Preliminary Structural Design of SSBWR-200

Technical Design-Features And Safety Analysis Of The 200 Mwt Nuclear Heating Reactor

Conceptual Design and Feasibility Analysis of a Modular Supercritical CO2 Fast Reactor Core

Preliminary study on small cogeneration BWR CR-200

Preliminary study on physical characteristics of single‐pass super‐critical water‐cooled reactor core

Analysis of Transient Characteristics and Design Improvement of the Passive Residual Heat Removal System of NHR-200-II

Analytical Studies of Long-Term IRWST Injection Core Cooling under Small Break LOCA in Passive Safety PWR

Fuel Storage Facilities for 200-MW Nuclear Heating Reactor

Thermalhydraulic Investigation Using a Test Facility Simulating 200 MW Integral Heating Reactor

New Structure Design for SCWR Internal Components

Conceptual design and analysis of a combined passive cooling system for both reactor and spent fuel of the pool-vessel reactor system

Preliminary Core Design of the Long Life S-CO2 Cooled Fast Reactor With 300WMth

The Conceptual Design of Emergency Core Cooling Scheme for Tsinghua High Flux Reactor

Design of the 200 MW normal-pressure reactor for district heating

Optimization of a Fuel Assembly for Supercritical Water-Cooled Reactor CSR1000

Analysis Of The Nhr-200 Nuclear Sea Water Desalination Plant And Its Interface Design

Analysis of Thermal Stratification Effects in the Ring Headers of the Passive Residual Heat Removal System of NHR-200-II

Numerical Simulation of the Transient Flow Characteristics and Thermal Stratification Phenomena in the Passive Residual Heat Removal System of NHR-200-II

Conceptual design of an indirect-cycle, supercritical-steam-cooled fast breeder reactor with negative coolant void reactivity characteristics

Preliminary study of system design and safety analysis methodology for supercritical carbon dioxide Brayton cycle direct-cooled reactor system

Numerical Simulation of Flow Distribution in the Lower Plenum of NHR200-II