Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Comparison of Load Models for Electromechanical Transient Simulation in BPA, PSASP and PSS/E

Comparison of three composite induction motor load models

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Influence of Load Models in Sending and Receiving Ends of Henan Power Grid on Tie-line Stability Limit of Sending End

Mechanism Analysis of Power Load Using Difference Equation Approach

Measured Dynamic Load Parameters and Power Network Stability Calculation

A Low-order Simplified Model of Power-electronic-interfaced Loads

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

Simplified Dynamic Model of the Electric Load Supplied by a Switching Power Supply

Load Modeling for Wide Area Power System

Comparative Studies on Load Modeling in Wide Area Power Systems

Load Modeling in China &#x2014;research, Applications &#x00026; Tendencies

Modeling Methods for Electric Loads in a Real Power Grid

Theory and practice of load modeling in power systems

A new generalized load model of power systems and its applications

Component Based On-line Modeling for Electric Loads

Comparison of analytical models for predicting electromagnetic performance in surface-mounted permanent magnet machines

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

PSS/E-based Electromechanical Transient Simulations of Load Models for Power Systems

Comparison of Mathematical Models for Transient Stability Between PSD-BPA and PSS/E

Comparison and Data Conversion Between Dynamic Models of BPA and DIgSILENT