Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Simplified Dynamic Model of the Electric Load Supplied by a Switching Power Supply

A Low-order Simplified Model of Power-electronic-interfaced Loads

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

Simplified Modeling of an Inverter Air Conditioner Based on Experimental Data

Simplified Modeling of Power Electronic Interfaced Load Considering Harmonics

On Static Load Model of Variable Frequency Based Motor Drive

Measured Dynamic Load Parameters and Power Network Stability Calculation

A new generalized load model of power systems and its applications

Mechanism Analysis of Power Load Using Difference Equation Approach

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Load Modeling with Considering Frequency Characteristic

Sequential Parameter Estimation of a Simplified Induction Motor Load Model

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

Comparison of three composite induction motor load models

Dynamic equivalent method of interconnected power systems with consideration of motor loads

Load Modeling for Wide Area Power System

Component Based On-line Modeling for Electric Loads

Simplified Model of Distributed PV Generation and Influence Analysis on Load Characteristics

Feasibility Study on the Characterization of Electric Load including Inverter Air Conditioner with a Synthetic Load Model

Nonlinear Dynamic Load Modelling: Model and Parameter Estimation

New method for on-line modelling of electric loads