Abstract:The static drill rooted nodular (SDRN) pile is a new type of composite pile that consists of a precast pile and surrounding cemented soil. Its cost advantages and environmentally friendly construction have been proven in applications in Southeast China. Moreover, the composition of pipe pile and nodular pile is based on the load transfer mechanisms of a pile foundation, which is effective in optimal design. This paper presents a field study on the behavior of SDRN piles under compression. The load-displacement response, axial force, mobilized load of pile cap, skin friction, and tip resistance of the composite pile are discussed. Here, the bilinear base load-displacement model was adopted to analyze the test results. It is found that providing caps on the static drill rooted piles takes full advantage of the static drill rooted method, and drilling and grouting into the soil beneath the cap, which can be considered a type of ground improvement treatment, can increase the bearing capacity of the pile cap; thus, setting a pile cap for this type of piles is recommended. The existence of the caps in the field tests decreased the skin friction of the upper part of pile shaft because of the additional settlement of the surrounding soil, which developed owing to the pressure from the caps. The frictional capacity of the concrete-cemented soil interface was much higher than that of the cemented soil-soil interface. The skin friction of the lower part of the pile shaft was about 1.25 times in clayey soil and 2.0 times in sandy soil compared with the bored pile. It can be concluded that the cemented soil-soil interface of the SDRN pile was probably better than the concrete-soil interface of the bored pile. The test results fitted the first stage curve of the bilinear model well, and it can be supposed that the base soil was strengthened because of the permeation of the cement paste.

The Experimental Study on New Technology for the Static Pressure of the PHC Tubular Piles

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Theoretical study of dynamic pore water pressure dissipation characteristics of open-hole pipe pile

Analysis of cast-in-situ tubular piles in soft foundation improvement at bridge approaches

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

Field Behavior of Pre-Stressed High-Strength Concrete Nodular Piles and PHC Pipe Piles Under Compression in Soft Soil Areas

Engineering Character of a New-Style Pretensioned Spun Concrete Nodular Pile

Field test of earth pressure at pile-soil interface by single pile penetration in silty soil and silty clay

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Technology and application of static drilling rooted geothermal energy pile

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

The engineering characteristic of precast tubular pile and mixing cement pile composite foundation for deep soft ground

Field Study of the Stress Development in PHC–steel Composite (PSC) Piles During Static Load Tests

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles

Research on Load Transfer Mechanism of Pre-Stressed High-Strength Concrete Nodular Pile Embedded in Deep Soft Soil

A Field Study on the Behavior of Static Drill Rooted Nodular Piles with Caps under Compression

Influence of Soil Reinforcement on the Uplift Bearing Capacity of a Pre-Stressed High-Strength Concrete Pile Embedded in Clayey Soil

A test on base bearing capacity of static drill rooted nodular pile

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Bearing Capacity And Load Transfer Mechanism Of Static Drill Rooted Nodular Piles