Abstract:Regional fine particulate matter pollution has become a common phenomenon recently.Controlling the emissions of fine particulate matter from coal-fired power plants is one of the most important ways to control fine particulate matter in the atmosphere.It is especially important to determine the size distribution of fine particles from coal-fired power plants and the possible causes of formation and influencing factors.Based on one 660 MW coal-fired power unit in Zhejiang Province,the Dekati ELPI + was applied to do multi-platform sampling testing for smoke at the inlet and outlet of the electrostatic precipitator,as well as the cross section of the chimney (60 m) at different operating conditions of 120,100,90 and 85 ℃.The goal was to study the size distribution characteristics of fine particles discharged fromn the power plant and how the emission concentrations of fine particulate matter is affected by different operating conditions.The results showed that:(1) Number concentration of particles was mainly concentrated on submicron modal (aerodynamic diameter smaller than 1 μm);with the increase of particle size,the number concentration rapidly decreased.(2) Both number concentration and mass concentration of fine particles at the outlet of the electrostatic precipitator decreased somewhat with the fall of flue gas temperature at the low-temperature economizer exit;nevertheless,when the temperature was reduced to 90 ℃,collection efficiency of the electrostatic precipitator tended to be roughly constant.(3) Mass concentration of particles at accumulation modal after the desulfurization device was higher than at the outlet of the electrostatic precipitator when the flue gas temperature at the low-temperature economizer exit was lower,regardless of whether designed coal or checked coal was burned.On the contrary,when the temperature was higher,the mass concentration of particles at coarse mode was relatively higher after the desulfurization device.(4) In the dilution ratio range chosen in this study,number concentrations of particles with aerodynamic diameter between 6 nm and 27 nm exponentially increased when the dilution ratio was increased from 7 to 10 times;the conclusion was that the number concentration of nanoparticles was affected mainly during dilution.(5) The removal efficiency (63.9％-99.8％) of the electrostatic precipitator was the highest for PM1 when the flue gas temperature was 90 ℃ after low-temperature economizer when the designed coal was burned.Thus,the trapping of PMt was promoted when the temperature of flue gas was low at the outlet of the electrostatic precipitator.

Microstructure and Composition of Inhalable Particulate Matter (PM10) from Coal-Fired Power Plants in Southwest China

Role of Minerals in the Evolution of Fine Particulate Matter During Pulverized Coal Combustion

Mineral Compositions of Individual Particles in the Inhalable Particulate Matter in the Lanzhou Air During Heating Period

Characteristics of particulate matter from emissions of four typical coal-fired power plants in China

Emission Characteristics of PM2.5 and Components of Condensable Particulate Matter from Coal-Fired Industrial Plants

Characterization Of Pm10 In Shanghai During 2005: Individual Particles Analysis

Composition Variation of PM10 During a Dust Storm Episode in Lanzhou, Northwestern China

Emission Characteristics of Particulate Matter from Coal-Fired Power Units with Different Load Conditions

Mineralogical Characteristics of PM_(10) Collected Before and During Dust Storm Episode in Lanzhou City,Northwestern China

Comparative Study on PM_(10) Microstructure and Heavy Metals Distribution in Emissions of Coal Combustion Sources

Distribution and Emission Characteristics of Filterable and Condensable Particulate Matter in the Flue Gas Emitted from an Ultra-Low Emission Coal-Fired Power Plant

Emission characteristics of PM10 and trace elements from a coal-fired power plant equipped with ESP

Microscopic morphology and size distribution of particles in PM 2.5 of Guangzhou City

Size Distribution Characteristics of Fine Particles from a Coal-Fired Power Plant

Investigations of Microscopic Morphology of Individual Inhalable Particulates in Macao in Summer

Study on emission characteristics of trace elements in PM_(10) from coal-fired power plant

Characteristics of condensable particulate matter before and after wet flue gas desulfurization and wet electrostatic precipitator from ultra-low emission coal-fired power plants in China

Emission of Organic Components and Distribution Characteristics of PAHs in Condensable Particulate Matter from Coal-Fired Power and Industrial Plants

Effects of Temperature and Chemical Speciation of Mineral Elements on PM10 Formation during Zhundong Coal Combustion

[Characteristics of Water-Soluble Inorganic Ions in PM2.5 Emitted from Coal-Fired Power Plants].

Effects of the Changes of Load and Flue Gas Temperature on the Emission of Particulate Matter from the Coal-Fired Unit