Abstract:Evolution of bainite in low carbon Nb-bearing microalloyed steels isothermally held below A_1 temperature was investigated by means of cold bending test, isothermal heat treatment, hardness measurement, optical microscopy and transmission electron microscopy (TEM). It is found that the evolution of bainite towards equilibrium and accompanied softening can be markedly slowed down by increasing of concentration product of carbon and niobium in the microalloyed steels. The effect works no matter whether the steel is subjected to pre-deformation. Cold deformation enhances the initial hardness of the steels while it largely accelerates softening and evolution of bainite towards equilibrium during post-heating. Almost same effects are observed for tensile strain and compressive strain. Cold deformation results in increasing of dislocation density and inhomogeneous dislocation distribution, the latter is the direct reason for pre-strain to promote microstructural evolution. The evolution of bainite during isothermal holding starts by redistribution of dislocations inside bainite laths, resulting in high density dislocations gathering along lath boundaries accompanied by occurring of zones with low density dislocations, followed by the zones with low dislocation density traversing lath boundaries and ferrite nucleating. The growth of ferrite by swallowing up the zones with high density dislocations and finally the microstructure evolves into polygonal ferrite.

Effect of Dissolved and Precipitated Niobium in Microalloyed Steel on Deformation Induced Ferrite Transformation (Dift)

Characteristics of Microstructural Evolution During Deformation-Enhanced Ferrite Transformation in Nb-microalloyed HSLA Steel

Effect of Nb on the Transformation Kinetics of Low Carbon (manganese) Steel During Deformation of Undercooled Austenite

Effect of Nb on deformation-enhanced ferrite transformation in low carbon steel

Microstructural Evolution in a 0.09% Niobium Low Carbon Steel during Controlled Hot Deformation

Microstructure evolution during deformation-enhanced transformation in Nb-microalloyed steel

Effects of Nano Precipitates in Austenite on Ferrite Transformation Start Temperature During Continuous Cooling in Nb–Ti Micro-alloyed Steels

Effect of non-isothermal deformation of austenite on ferrite transformation behavior studied by in-situ neutron diffraction

Effect of Content of Carbon and Niobium on Thermal Stability of Bainite in Microalloyed Steels

Precipitation Behavior of Nb in Hot-Rolled Nb-microalloyed TRIP Steel During High-Temperature Deformation

Effect of Dissolved Niobium on Eutectoid Transformation Behavior

Effect of Nb, Ti microalloying on hot deformation behavior of high strength steel

Effect of Niobium on Isothermal Transformation of Austenite to Ferrite in HSLA Low-Carbon Steel

Effect of Deformation Parameters on Microstructure Evolution, Flow Softening Behavior and Nanoindentation Properties of Nb–24Ti–16Si–2Al–4Fe–5V Alloy

Microstructure Evolution In A Low Carbon Nb-Ti Microalloyed Steel

Effect of Niobium Modification on Solidification and Crystallization Mechanism of Medium-Carbon Cast Steel

Strain-Induced Precipitation Of Nb(Cn) During Deformation Of Undercooled Austenite In Nb-Microalloyed Hsla Steels

The Influence of the Hot-Rolling Temperature on the Microstructure and Mechanical Properties of Ti-Nb Microalloyed 21%Cr Ferritic Stainless Steel

Mechanical Behavior and Martensitic Transformation of an Fe–Mn–Si–Al–Nb Alloy

Microstructural evolution during the austenite-to-ferrite transformation from deformed austenite

Effect of Niobium on Inclusions in Fe-Mn-C-Al Twinning-Induced Plasticity Steel