Boron continuous recovery from brines by the multicolumn simulated moving bed process with boron chelating resin
Liqiang Shao,Chen Sheng,Mengxiang Lu,Ying Yang,Ping Li
DOI: https://doi.org/10.1016/j.jwpe.2023.103875
IF: 7
2023-07-01
Journal of Water Process Engineering
Abstract:The objective of this work is to develop an advanced adsorption process to continuously recover and remove boron from brines. Firstly, the adsorption and desorption performances of boron on the commercially available N-methylglucamine resin (D403 resin) are evaluated, then, the cyclic adsorption and desorption process is investigated experimentally in the fixed bed adsorber for boron recovery from brine. It is confirmed that the cyclic process involves five steps, such as boron recovery from brine, water washing 1 to remove the retained brine, boron desorption to obtain boron-rich solution, water washing 2 to recover the retained HCl solution, and resin regeneration for the reuse. Furthermore, the seven-column simulated moving bed (SMB) process with four zones is designed and investigated experimentally. Experimental results demonstrate that boron can be recovered continuously from brine in adsorption zone, and boron-rich solution is obtained continuously in desorption zone. When the inlet brine contains a low boron content (for example 296.5 mg/L), most boron in brine can be recovered by the seven-column SMB unit with 96.8 % boron adsorption efficiency, and the discharged brine contains 8.77 mg/L boron, approximately meeting the environmental protection requirement for the limitation of boron emission. Therefore, the simultaneous recovery and removal of boron from brine can be achieved by the proposed multicolumn SMB process.
engineering, chemical, environmental,water resources