Theoretical Analysis And Experimental Study On Thermal Stability Of High-Speed Motorized Spindle
Zhe Liu,Wei Chen,Desheng Li,Wenjing Zhang
DOI: https://doi.org/10.1108/ILT-04-2016-0091
2017-01-01
Industrial Lubrication and Tribology
Abstract:Purpose - In high-speed processing, the influence on the machining accuracy of a machine tool is greatly caused by the thermal deformation of the motorized spindle; a further study on the thermal characteristics of the spindle is given in this paper. This study aims to reduce the thermal error and improve the performance of the machine tool by discussing the relationships between the temperature distributions and rotating accuracy caused by the thermal deformations of the spindle.Design/methodology/approach - The paper opted fora method combining the theoretical analysis and the experimental study to study the thermal stability of the high-speed motorized spindle. First of all, a finite element model of the spindle was built with ANSYS, whereby temperature distributions and the thermal deformations were successively obtained at different speeds. And then, both the temperature field and the rotating accuracy of the motorized spindle were measured simultaneously by the thermal stability experiment. Finally, the experimental and theoretical results were compared and validated.Findings - The thermal stability of the motorized spindle was studied in this paper, and some findings from the study were as follows: the spindle's rotating accuracy maintained good in X direction but bad in Y and Z directions in terms of the deformations; the higher front-end temperature of the spindle which can significantly affect the rotating accuracy is needed to be controlled mainly; the recovery speed of the spindle deformation lagged behind the temperature's fallback speed; the vibration graph about radial rotating sensitivity synthesized by X1 and X2 presented a trifoliate shape.Originality/value - Based on a built test-bed which can synchronously measure the motorized spindle's temperature distribution and rotating accuracy with five-point method, the coupling effects of the thermal deformation and temperature are embodied, and not only the vibration graph but also the thermal tilt angles can be gained. Therefore, considering the influence of the thermal deformation on the heat generated by the bearings, the paper fulfilled a study by which it was obtained that the front-end temperature of the spindle, which was higher and could significantly affect the rotating accuracy, needed to be controlled mainly.