Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Several Key Points in Applying the Twin Shear Unified Strength Theory to CFT

Flexural strength analysis of non-post-tensioned and post-tensioned concrete-filled circular steel tubes

Analytical Studies of Concrete-Filled Circular Steel Tubes under Axial Compression

Confined Concrete-Filled Tubular Columns

Behaviour of CFT and CCFT columns under impact loads

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Studies on Constitutive Relationship for Concrete Filled Steel Tube

Torsional Ultimate Bearing Capacity of Centrifugal Concrete Filled Steel Tube Based on Model of Failure Line

Axial Strength of Square and Rectangular CFT with Binding Bars Based on Unification Theory

Analysis and Simplified Calculation of Mechanical Behavior of Concrete-Filled Steel Short Columns under Axial Compression Based on Three Parameters

FOUMULA OF THE AXIAL STRENGTH OF S-CFT WITH BINDING BARS BASED ON UNIFICATION THEORY

Experimental and theoretical analysis for centrifuge concrete filled-steel tubular members subjected to bending-torsion

Study on the working mechanism and behavior of centrifuge concrete filled-steel tubular(CCFT) members subjected to torsion

Punching shear failure of concrete-filled steel tubular CHS connections

Experimental Investigation and Design of Concrete-Filled Steel Tubular CHS Connections

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Basic behavior of high-strength concrete-filled steel tubular short columns under axial compressive loading

Unified theory on the capability of hollow polygonal CFST compression and bending members

Investigation on Concrete Filled Double Skin Steel Tubes (cfdsts) under Pure Torsion

STUDY ON BEHAVIOR OF CONCRETE FILLED ELLIPTICAL STEEL TUBE MEMBERS PART II: UNDER BENDING AND ECCENTRIC COMPRESSION

Experimental and numerical study on shear behaviour of concrete-filled double-skin steel tubular structures