Abstract:Numerical simulation is an important method to study the penetration into targets. Distinct results may be acquired if different kinds of software are adopted. In this paper, three kinds of commonly-used softwares (LS-DYNA, ABAQUS and PAM-CRASH) were adopted to simulate the same series of penetration experiments. The simulation results were analyzed and the advantages and disadvantages of each kind of software were compared. The purpose of this work is to help the researchers and engineers to select the most suitable software. The results in this paper demonstrate that the calculation results of the three kinds of software are basically consistent with the experimental results. The simulation results of the flat-headed projectile are generally better than those of the hemispherical projectile. The residual velocity of the projectile and the plug velocity were simulated well using all of the three kinds of software. The calculated velocities by ABAQUS and PAM-CRASH are closer to the experimental results, and the average relative errors are generally lower than 15%. Moreover, the errors from most calculation results by PAM-CRASH are even less than 10%. However, for the deformation of the projectile, the calculation results of the three kinds of software are quite different from the experimental ones. There are other differences in the performance of the three kinds of software. For example, the ballistic limits calculated by ABAQUS and LS-DYNA are higher than the experimental results, while those by PAM-CRASH are lower. ABAQUS is most likely to report errors but is balanced by calculation time and effects. LS-DYNA has a low error rate and good robustness. The change of model parameters (such as mesh density, friction coefficient, contact stiffness, viscous damping coefficient, etc.) has little effect on its calculation results. PAM-CRASH is greatly affected by model parameters. The conclusion of this paper is based on the following conditions: the target material is Weldox 460E steel, the projectile is ARNE tool steel, and the impact velocity range is 180－450 m/s. However, it is also of guiding significance for the penetration problem simulation of other materials in this velocity range.

Ultra-high G Deceleration–time Measurement for the Penetration into Steel Target

Investigation on the anti-penetration performance of the steel/nylon sandwich plate

Study on Penetration of Concrete Targets by Ogive-Nose Steel Projectile

Triaxial Acceleration Measurement For Oblique Penetration Of A Rigid Projectile Into Concrete Target

Triaxial Acceleration Measurement for Oblique Penetration into Concrete Target.

Comparative study of numerical simulations of projectile penetration into metal targets

Scaled Experiment of the Detonation Control System for the High-Speed Penetration on Concrete

Numerical simulation of high speed penetration into concrete by steel projectiles

Penetration Trajectory of Concrete Targets by Ogived Steel Projectiles–experiments and Simulations

Research Development of High G Penetration Acceleration Test and Its Correlative Technology

Analysis of the velocity relationship and deceleration of long-rod penetration

Study on Acceleration Test Technique of High Velocity Kinetic Energy Projectile Penetrating into Hard Target

Numerical Simulation Research on Steel/ceramic Composite Target Plate Structure Against Penetration of High-Speed Projectile

Acceleraton Shock Test Technology with Higher Values of G

Low-velocity Penetration Behavior of Ice by Steel Projectile

Experimental and theoretical study on steel long-rod projectile penetration into concrete targets with elevated impact velocities

Hypervelocity penetration of concrete targets with long-rod steel projectiles: experimental and theoretical analysis

Experimental research on the mechanism of a high-velocity projectile penetrating into a reinforced concrete target

Thick Plain Concrete Targets Subjected to High Speed Penetration of 30crmnsini2a Steel Projectiles: Tests and Analyses

Study of the Axial Density/impedance Gradient Composite Long Rod Hypervelocity Penetration into a Four-Layer Q345 Target

Experiment and numerical simulation on penetration of polycarbonate projectile into target