Abstract:Introduction Low coherence interferometry offers the possibility of solving the ‘powering up’ problem associated with all fibre optic interferometric sensors used to measure slowly varying measurands such as temperature or displacement. In a typical system, the remote sensor is illuminated with the output form a source with low temporal coherence and interrogated using a second interferometer which is scanned such that its optical path difference (OPD) is maintained to be exactly equal to that of the sensor. In order that fibre optic sensors can compete with conventional electronic sensors it is desirable to be able to multiplex several sensors. A variety of multiplexing configurations for interferometric sensors exploiting low coherence processing have been developed, which include coherence tuning(l) and time division multiplexing (TDM)(2). Practical difficulties are experienced with both techniques. The main problems with coherence tuning are i) the optical path length of each sensor must be different (incremented by the source coherence length) which imposes restrictions on the sensor designs, particularly in the case for a network of miniature sensors, and ii) very high cross talk levels, as the recovered signal contains both the desired signal for the coherence tuned sensor and uncorrelated optical power from all the other sensors in the network, which inevitably results in very poor S/N ratios. The noise associated with the uncorrelated signals can be eliminated by exploiting TDM, however, as it is necessary to sequentially coherence match the local receiving interferometer (LRI) to each sensor, the technique is difficult to use in practice. Here we report two novel partially multiplexed configurations where the problems listed above can be solved by fully multiplexing the scanning interferometer and the signal processing unit, whilst at the same time the sensor network is only partially multiplexed. Configuration (1) Long Rang Tracking The basic optical configuration for long range tracking is shown in figure la. The output beam from a low coherence optical source (LCOS) is first collimated and directed into the transmission Michelson interferometer (TMI). The output signal of this interferometer is then injected into a 50/50 multimode coupler and then used to illuminate the two bulk optic Michelson interferometers acting as sensor simulators.

Coherence Multiplexing System Based on Asymmetric Mach–Zehnder Interferometers for Faraday Sensors

Coherence Multiplexing of Sensors Based on Long-Period Fibre Grating Mach-Zehnder Interferometers

Optical Coherence-Multiplexed Sensors Based on In-Fiber Michelson

A Novel Demodulation Scheme of Fiber-Optic Interferometric Sensor Based on FM SSB Signal

A New Magnetic Sensor with Mach-Zehnder/Sagnac Optical Fiber Interferometer

Low-Coherence Interrogation Scheme for Multiplexed Sensors Based on Long-Period-Grating Mach-Zehnder Interferometers

Coherence Multiplexing of Distributed Sensors Based on Pairs of Fiber Bragg Gratings of Low Reflectivity

Simple multiplexing schemes for sensor networks exploiting low coherence interferometry

Multiplexing of Fabry-Pérot Sensor by Frequency Modulated Continuous Wave Interferometry for Quais-Distributed Sensing Application

Quasi-Distributed Absorption Sensing System Based on a Coherent Multiplexing Technique

Seawater temperature and salinity sensing based on in-fiber Michelson-Fabry-Perrot hybrid interferometer employing frequency domain decomposition method

An Integrated Fiber Michelson Interferometer Based on Twin-Core and Side-Hole Fibers for Multiparameter Sensing

Study of polarization-insensitive fiber optic michelson interferometric sensors

Passive quadrature demodulation of birefringent low-finesse fiber-optic Fabry-Perot interferometric sensors

Triple detection fiber differentiating interferometer based on low-coherence interferometer and its passive demodulation scheme

Twin Multiplexing Strain Sensing Array Based on a Low-Coherence Fiber Optic Mach–Zehnder Interferometer

Multibeam Interferometer Using a Photonic Crystal Fiber with Two Asymmetric Cores for Torsion, Strain and Temperature Sensing

Few-mode Multicore Fiber Enabled Integrated Mach-Zehnder Interferometers for Temperature and Strain Discrimination.

Multiplexing Optical Fiber Low Coherence and High Coherence Interferometric System with Large Range and High Resolution for On-Line Measurement

Polarization Maintaining Fiber Magnetic Sensor Based on the Digital Phase Generated Carrier Technology

Multi-modes Interferometer for Magnetic Field and Temperature Measurement Using Photonic Crystal Fiber Filled with Magnetic Fluid