Abstract:New heat capacity measurements, for both single phase liquid and two-phase liquid-vapor states, were carried out using an adiabatic calorimeter. A high purity sample of dimethyl ether was used for these measurements. To derive values for Cδ and pδ, the two-phase heat capacity data were treated in terms of internal energy and entropy surfaces. In this way, thermodynamically consistent values of saturated liquid heat capacity and vapor pressure were derived in a temperature range from the triple point of dimethyl ether near 132 K to the upper temperature limit of the calorimeter near 345 K. The expanded uncertainty for values of Cδ were 0.7 %, while for pδ, it ranged from 2 Pa near the triple point temperature to 50 Pa near the normal boiling temperature. The derived thermodynamic data at saturation were fitted by simple functions of temperature that cover wide ranges (150°-200°C) of temperature, which increases their utility for process design. These fitted functions were also used to make direct comparisons with the limited published data for Cδ and pδ. This is an abstract of a paper presented at the AIChE Spring National Meeting and 5th Global Congress on Process Safety (Tampa, FL 4/26-30/2009).

Viscosity of Saturated Liquid Dimethyl Ether from (227 to 343) K

Experimental Measurement and Modeling of the Viscosity of Dimethyl Ether

Density and Viscosity of Saturated Liquid Dimethoxymethane from (218.15 to 383.15) K

Surface Tension of Dimethyl Ether from (213 to 368) K

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

KINEMATIC VISCOSITY OF SATURATED LIQUID DMM

Measurement of the Critical Parameters and the Saturation Densities of Dimethyl Ether

Gaseous viscosity of dimethyl ether in the low density region

Heat Capacity of Saturated and Compressed Liquid Dimethyl Ether at Temperatures from (132 to 345) K and at Pressures to 35 MPa

Viscosity of Saturated Liquid Methyl tert-Butyl Ether

Density and viscosity measurements of diethylene glycol dimethyl ether

Measurement of saturated liquid density of dimethyl ether

Density and Viscosity Measurements of Diethyl Ether from 243 to 373 K and Up to 20 MPa

Experimental Investigation of the Viscosity of Saturated Liquid Dimethyl Carbonate

Vapor Pressure Measurements of Dimethyl Ether from (213 to 393) K

Thermodynamic properties of saturated liquid dimethyl ether from adiabatic calorimetry

Vapor Pressure Measurements of Dimethyl Ether from (233 to 399) K

Density, Viscosity, and Surface Tension at 293.15 K and Liquid−Liquid Equilibria from 301.15 K to 363.15 K under Atmospheric Pressure for the Binary Mixture of Diethylene Glycol Diethyl Ether + Water

Thermal Conductivity of Gaseous Dimethyl Ether from (263 to 383) K

Density and Viscosity Measurements of Dimethoxymethane and 1,2-Dimethoxyethane from 243 K to 373 K up to 20 MPa

DEVELOPMENT OF A VIBRATING TUBE DENSIMETER AND MEASUREMENT OF SATURATED LIQUID DENSITY OF DIMETHYL ETHER