Abstract:The adsorption behaviors of extended anionic surfactants linear sodium dodecyl(polyoxyisopropene)4 sulfate (L-C12PO4S), branched sodium dodecyl(polyoxyisopropene)4 sulfate (G-C12PO4S), and branched sodium hexadecyl(polyoxyisopropene)4 sulfate (G-C16PO4S) on polymethylmethacrylate (PMMA) surface have been studied. The effect of branched alkyl chain on the wettability of the PMMA surface has been explored. To obtain the adsorption parameters such as the adhesional tension and PMMA-solution interfacial tension, the surface tension and contact angles were measured. The experimental results demonstrate that the special properties of polyoxypropene (PO) groups improve the polar interactions and allow the extended surfactant molecules to gradually adsorb on the PMMA surface by polar heads. Therefore, the hydrophobic chains will point to water and the solid surface is modified to be hydrophobic. Besides, the adsorption amounts of the three extended anionic surfactants at the PMMA–liquid interface are all about 1/3 of those at the air–liquid interface before the critical micelle concentration (CMC). However, these extended surfactants will transform their original adsorption behavior after CMC. The surfactant molecules will interact with the PMMA surface with the hydrophilic heads towards water and are prone to form aggregations at the PMMA–liquid interface. Therefore, the PMMA surface will be more hydrophilic after CMC. In the three surfactants, the branched G-C16PO4S with two long alkyl chains exhibits the strongest hydrophobic modification capacity. The linear L-C12PO4S is more likely to densely adsorb at the PMMA–liquid interface than the branched surfactants, thus L-C12PO4S possesses the strongest hydrophilic modification ability and shows smaller contact angles on PMMA surface at high concentrations.

Effects of Concentration of Nonionic Surfactant and Molecular Weight of Polymers on the Morphology of Anisotropic Polystyrene/poly(methyl Methacrylate) Composite Particles Prepared by Solvent Evaporation Method

Tuning polymer blends to cocontinuous morphology by asymmetric diblock copolymers as the surfactants

Preparation of Poly (methacrylic Acid)/polystyrene Composite Particles and Morphology Control

Effects of Molecular Weight, Solvent and Substrate on the Dewetting Morphology of Polystyrene Films

Effects of Poly(ethylene Glycol) Molecular Weight on the Stability of Surfactant-Free Emulsion Polymerization System Consisting of Styrene and Methyl Methacrylate

Effect of Polystyrene‐b‐poly(ethylene Oxide) on Self‐assembly of Polystyrene‐b‐poly(n‐isopropylacrylamide) in Aqueous Solution

Effect of Surfactant Concentration on the Complex Structure of Poly(N-isopropylacrylamide)/Sodium N-Dodecyl Sulfate in Aqueous Solutions

Effect of Polymer-Substrate Interactions on the Surface Morphology of Polymer Blend Thin Films

THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION

Rheological behaviour and adsorption phenomenon of a polymer-particle composite based on hydrolysed polyacrylamide/functionalized poly(styrene-acrylic acid) microspheres

Solvent Effect on the Surface Morphology of Polymer Blend Thin Films During Spin-coating Process

Effect of hydrophilic comonomer and surfactant type on the colloidal stability and size distribution of carboxyl- and amino-functionalized polystyrene particles prepared by miniemulsion polymerization.

Controllable Morphology and Wettability of Polymer Microspheres Prepared by Nonsolvent Assisted Electrospraying

Surface Morphology Evolution of Poly (Styrene-Block-4-vinylpyridine) (Ps-B-p4vp)(h+) and Poly(Methyl Methacrylate)-Dibenzo-18-Crown-6-Poly(Methyl Methacrylate) (pmcma) Supramolecular Film

Wettability of a Polymethylmethacrylate Surface by Extended Anionic Surfactants: Effect of Branched Chains

Studies on the Surface Morphology of Poly (Styrene-B-dimethylsiloxane) Copolymer Thin Films

Effects of Solvent Treatment on Surface Morphology and Composition of Poly(Methyl Methacrylate)-G-Poly(Ethylene Oxide)

Effect of Solvents on the Performance and Structure of Polymethylacrylimide Aerogels

Effects of Ionic Monomer and Colloidal Silica on Preparation of Polystyrene Microsphere

Covalently Bonded Polystyrene/Sio2 Microspheres Via Emulsion Polymerisation Stabilised Solely by Surface Active Pickering Stabiliser

MEAN-SQUARE RADIUS OF GYRATION AND DIPOLE MOMENT OF POLY(METHYLPHENYLSILOXANE) CHAINS