Preparation, Characterization and Luminescence Properties of Porous Si3N4 Ceramics with Eu2O3 As Sintering Additive

Fangli Yu,Jianfeng Yang,Anneke C. A. Delsing,Bert H. T. Hintzen
DOI: https://doi.org/10.1016/j.jlumin.2010.07.008
IF: 3.6
2010-01-01
Journal of Luminescence
Abstract:Porous Si3N4 ceramics with photoluminescence properties were prepared by pressureless sintering using α-Si3N4 powder as raw material and Eu2O3 as sintering additive. Chemical composition, phase formation, microstructure and photoluminescence properties of porous Si3N4 ceramics were studied by X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), scanning electron microscopy (SEM) and photoluminescence measurements (PL/PLE). The results show that single Eu2O3 additive promotes α→β transformation but not significant densification. A broad band emission center at 570nm assigned to Eu2+ is observed, Eu3+ in Eu2O3 is (partially) converted to Eu2+ by reaction with Si3N4, which results in a lower β aspect ratio and β-content compared to the other Ln (Ln=lanthanide) oxide additives.
What problem does this paper attempt to address?