Abstract:A detailed assessment of the thermo-mechanical limits of the ITER divertor with respect to potential excessive local transient heat loads due to Edge Localised Modes (ELMs) has revealed a particular power loading scenario arising from the fact that ELM ions expelled from the upstream pedestal region will arrive at the divertor target plates without substantial thermalisation. As a consequence of their Larmor gyration around magnetic field lines, they are able to penetrate toroidal gaps between individual monoblocks of the target plate structure and can deliver rather intense heat loads to monoblock side faces near the gap entrance. To verify that this ELM-induced loading, predicted by both ion orbit simulations and particle in cell simulations, really does occur, two dedicated experiments have been performed on the ASDEX Upgrade tokamak. In both experiments a model toroidal gap structure of similar dimensions to those of the ITER divertor target monoblocks was exposed to a series of identical H-mode discharges with strong type-I ELMs. The effects arising from the gyro motion of hot ELM ions were identified by inverting, in the second experiment, the directions of both toroidal field and plasma current, thus reversing the ion gyration direction. The local distribution of incident ion flux on the gap side faces was quantified by pre- and post-exposure analysis of platinum marker layers to determine quantitatively the erosion rate of the platinum marker. The results fully confirm the ion orbit code predictions with respect to the penetration depth of incident ions with gyro orbits of similar or larger radius than the gap width. Moreover, the results confirm that ELM ions do indeed arrive at the divertor with their typical pedestal energies and also allow conclusions to be drawn regarding the corresponding intra-ELM ion particle and power flux, which is not easy to quantify using Langmuir probes.

Wall and Divertor Load during ELMy H-mode and Disruptions in ASDEX Upgrade

Interaction of ELMs and fast particles with in-vessel components in ASDEX Upgrade

Investigation of ELM-related Larmor ion flux into toroidal gaps of divertor target plates

An extensive analysis of SOL properties in high-δ plasmas in ASDEX Upgrade

Impact of divertor neutral pressure on confinement degradation of advanced tokamak scenarios at ASDEX Upgrade

Type-I Elm Power Loads On The Closed Outer Divertor Targets In The Hl-2a Tokamak

Investigation of pedestal parameters and divertor heat fluxes in small ELM regimes on DIII-D

Evaluation of Performance for the East Upgraded Divertor Targets During Type I Elmy H-Mode

Near- and far scrape-off layer transport studies in detached, small-ELM ASDEX Upgrade discharges by means of EMC3-EIRENE

MHD simulations of small ELMs at low triangularity in ASDEX Upgrade

Divertor enrichment of recycling impurity species (He, N 2 , Ne, Ar, Kr) in ASDEX Upgrade H-modes

MHD simulations of formation, sustainment and loss of Quiescent H-mode in the all-tungsten ASDEX Upgrade

Overview of ASDEX Upgrade results in view of ITER and DEMO

Effect of local wall clearance on scrape-off layer electron density profiles in ASDEX Upgrade

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Study of Divertor Heat Flux Widths in Type-I Elmy H-Mode with Infra-Red Thermography on East Tokamak

Thermo-mechanical and Damage Analyses of EAST Carbon Divertor under Type-I ELMy H-mode Operation

An experimental investigation of the high density transition of the scrape-off layer transport in ASDEX Upgrade

Divertor heat fluxes and profiles during mitigated and unmitigated Edge Localised Modes (ELMs) on the Mega Amp Spherical Tokamak (MAST)

Developing steady state elm-absent h-mode scenarios with advanced divertor configuration in east tokamak

Progress on In-Vessel Poloidal Field Coils Optimization Design for Alternative Divertor Configuration Studies on the EAST Tokamak