Abstract:This paper presents the design of a low power (8 W) water-fed vaporizing liquid microthruster that operates in the Leidenfrost boiling regime. The direct thrust measurements show the proposed design is able to produce one of the best specific impulse amongst all similar microthrusters reported in the literature. One of the important features that enables the superior performance is the high heat flux miniature molybdenum heating elements fabricated inside the vaporization chamber in a single silicon device package of dimensions 35 mm. 35 mm. 1.05 mm. The molybdenum heating elements are capable of producing a heat flux output of 370 kW/m(2) resulting in a sustained operational pressure of 2 bar and temperature of 446 K. The specific design details, such as choice of configurations and sizing, are given in this paper. In particular, the choice of material and the fabrication process carried out at the in-house nanosystem fabrication facility are described. The experimental setup and uncertainty analysis of the mN-range hanging pendulum direct thrust measurement stand are presented. Then, the evaporation of liquid water propellant is investigated in detail. The occurrence of Leidenfrost effect inside the vaporization chamber is captured with a high-speed camera at a frame rate of 5000 Hz. It can be seen that the rapid vaporization of propellant in the Leidenfrost boiling regime results in a high specific impulse amongst other microelectromechanical-system-scale vaporizing liquid microthrusters. The direct thrust measurements show the current design is capable of producing a specific impulse ranging between 25.9-51.1 s at a continuous thrust level of 1.00-2.00 mN; considering contemporary energy storage technologies, the estimated thrust per device dry mass and specific impulse per device dry mass levels are 4.0-8.0 mN/kg and 103.6-204.0 s/kg respectively.

Investigation of the Onset Voltage for the Design of A Microfabricated Colloid Thruster

Research on electric field and electric breakdown problems of a micro-colloid thruster

Development of a MEMS Based Colloid Thruster with Sandwich Structure

Designing, Fabrication, and Test of a MEMS Colloid Thruster

Research On Colloid Thruster And Thrust Measurement System

Computationally examining the effect of plate thickness on hole emitter type electrospray thrusters

Measurement of μN thrust for the micro colloid thruster

Measurement Of Mu N Thrust For The Micro Colloid Thruster

Design of Magnetically Enhanced Hollow Cathode Micro-Thruster: Concept and Experimental Research

Study of a Vaporizing Water Micro-Thruster

Study on the Ionization and Acceleration of a Microwave Discharge Cusped Field Thruster

Investigation on the Radial Distribution of Electron Density in a Miniaturized ECR Ion Thruster of Wide-Range Operations

Diagnostic and Modelling Investigation on the Ion Acceleration and Plasma Throttling Effects in a Dualemitter Hollow Cathode Micro-Thruster

Design and Fabrication of a Novel Microthruster Based on Electrochemical Principle

Study on the Peak Current of Power Supply During a Hall Thruster Start-Up

Design and Testing of a Microelectromechanical-System-based High Heat Flux Vaporizing Liquid Microthruster

A Vaporizing Water Micro-Thruster

Fabrication and characterization of a fully conventionally machined, high-performance porous-media electrospray thruster

Emission Performance of Ionic Liquid Electrospray Thruster for Micropropulsion

Experimental investigation on current modes of ionic liquid electrospray from a coned porous emitter

Experimental and Numerical Studies of Low Power Hall Thruster Performance