Abstract:Rigid-plastic finite element method considering, thermo-mechanical coupling was used to investigate the thermal forging process of a cubical-shaped 7075 aluminum alloy piece, and the Yada model was adopted to calculate the grain refinement in the process. The simulation results show that the distribution of stress, strain, strain rate and temperature of the forging piece are not uniform, and according to the distribution of these physical quantities, the forging piece can be divided into four characteristic zones: the center ellipsoidal zone, the contact edge zone, the vertical edge zone and conical contact zone, where the first two zones are easy to deform, and the remained two zones are difficult to deform. The grain refinement begins from the center ellipsoidal zone, and then gradually expands to the vertical edge zone and conical contact zone. The comparison analysis of different forging parameters shows that temperature and compression strain rate is the major forging parameters controlling grain size. The grains of 7075 aluminum alloy can be further refined. with the increase of compression strain rate, but high compression strain rate will bring the excessive heat that will make grains to grow. Then a set of suggested forging parameters are given as follows, the initial temperature should be 350 degrees C similar to 400 degrees C, the compression strain rate should be 70 s(-1)similar to 100 s(-1), and the compression ratio should be 20%similar to 25%. And finally, the limitation and application region of Yada model are also discussed.

Effects of Process Parameters on the Temperature Field in Ti-6Al-4V Alloy Blade Precision Forging Process

RESEARCH ON INFLUENCE OF TEMPERATURE ON A PRECISION FORGING PROCESS OF BLADE WITH A TENON

Influence of processing parameters on microstructure evolution during blade precision forging process of titanium alloy

Numerical Simulation of Hot Die Forging Process of Ti-6Al-4V Alloy Blade

3D Coupled Thermo-Mechanical FEM Simulation in Precision Forging Process of Blade with Tenon

Effect of Process Parameters on Deformation and Temperature Rise During Forging of TC6 Alloy Disc

Prediction of Grain Size for Blade Precision Forging Process under Thermo-Mechanical Coupling

Influence of forging velocity on temperature and phases of forged Ti-6Al-4V turbine blade

Research on the Temperature Distribution in the Precision Forging Process of the Blade with a Damper Platform

Effect of Process Parameters on Microstructural Variables of a Commercial TC6 Titanium Alloy Disc

Numerical simulation of grain refinement of 7075 aluminum alloy in forge processing

FE simulation of grain size and temperature rise during the forging of a commercial TC6 titanium alloy disc

Coupled Thermo-Mechanical Analysis of the High-Speed Hot-Forging Process

Application of FEM Simulation to the Effects of Working Parameters on Isothermal Forging of 7075 Aluminum Alloy

Effect of Processing Parameters on Microstructure and Mechanical Properties in High Temperature Deformation of Ti-6Al-4V Alloy

Thermal Simulation Model of Aero-Engine Blade Material Forging Simulation

Precision Forging Process Analysis and Preform Optimization of Small Compressor Blade of Titanium Alloy

Optimization of hot deformation parameters for multi-directional forging of Ti65 alloy based on the integration of processing maps and finite element method

Application of Thermohydrogen Processing to Ti6al4v Alloy Blade Isothermal Forging

EFFECTS OF HOT FORGING TEMPERATURE ON MICROSTRUCTURE AND MECHANICAL PROPERTY OF TG6 HIGH TEMPERATURE TITANIUM ALLOY

High Nb–TiAl Intermetallic Blades Fabricated by Isothermal Die Forging Process at Low Temperature