Abstract:Removing the gearbox from the single-motor configuration of an electric vehicle (EV) would improve motor-to-wheel efficiency by preventing mechanical losses, thus extending the autonomy of the EV. To this end, a permanent-magnet Vernier machine (PMVM) is designed to ensure such operation. This machine avoids the high volume and large pole-pair number of the armature winding since its operating principle resembles that of a synchronous machine with an integrated magnetic gear. Therefore, such a structure achieves low-speed and high-torque operation at standard supply frequencies. From the specification of an urban vehicle, the required specification for direct-drive operation is first determined. On this basis, an initial prototype of a Vernier Machine with permanent magnets in the rotor that can replace the traction part (motor + gearbox) is designed and sized. This first prototype uses radial contiguous surface-mounted magnets and its performance is then analyzed using finite element analysis (FEA), showing a relatively high torque ripple ratio. The rotor magnets are then arranged in a quasi-Halbach configuration and simulations are performed with different stator slot openings and different ratios of the tangential part of the magnet in order to quantify the effect of each of these two quantities in terms of average torque, torque ripples and harmonics of the back-electromotive force at no load. Since the design and optimization of this motor is finite element-assisted, a coupling process between FEA Flux software and Altair HyperStudy is implemented for optimization. This method has the advantages of high accuracy of the magnetic flux densities and electromagnetic torque estimates, and especially the torque ripples. The optimization process leads to a prototype with an average torque value that meets the specification, along with a torque ripple ratio below 5% and a high power factor, while keeping the same amount of magnet and copper.

Construction of Permanent-Magnet Electric Variable Transmissions for Hybrid Electric Vehicles

Efficiency Optimization of PMSM Drives Using Field-Circuit Coupled FEM for EV/HEV Applications

Optimization Design of an Interior Permanent-Magnet Synchronous Machine for a Hybrid Hydraulic Excavator

Performance Analysis of Magnetically Geared Permanent Magnet Brushless Motor for Hybrid Electric Vehicles

Comparison of PMSMs with Different Rotor Structures for EV Application

Hev System Based On Electric Variable Transmission

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Comparison of Direct-Drive Permanent-Magnet Synchronous Motor and Permanent-Magnet Flux-Modulated Motor for Electric Vehicles

Quantitative Comparison of Partitioned-Stator Machines for Hybrid Electric Vehicles

A novel double stator hybrid-excited Halbach permanent magnet flux-switching machine for EV/HEV traction applications

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Optimum Design of an Extended Range Generator for EVs Based on Taguchi Method

A Novel Dual Rotor Flux-Bidirectional-Modulation Machine for Hybrid Electrical Vehicles

Study on the Design and Speed Ratio Control Strategy of Continuously Variable Transmission for Electric Vehicle

Research on a four-phase fault-tolerant PMSM used for EVs

Performance evaluation and optimization of a novel plug-in power-reflux hybrid electric vehicle powertrain

Design of Quasi-Halbach Permanent-Magnet Vernier Machine for Direct-Drive Urban Vehicle Application

High Efficiency Hybrid Synchronous Motor Design with Loss and Thermal Analysis for Integrated Two-Speed e-Powertrain System in Electric Vehicles

Comparative Study of High Torque Density Spoke-Type PM In-Wheel Motors for Special Vehicle Traction Applications

Analysis of a Hybrid Permanent Magnet Variable-Flux Machine for Electric Vehicle Tractions Considering Magnetizing and Demagnetizing Current

Low-stiffness comfort shift characteristics of a permanent magnet two-speed transmission for low-speed EV