Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

Optimum Design of an Extended Range Generator for EVs Based on Taguchi Method

Efficiency Optimization of PMSM Drives Using Field-Circuit Coupled FEM for EV/HEV Applications

Optimization Design of a Permanent Magnet Synchronous Generator for a Potential Energy Recovery System

Optimization Design of an Interior Permanent-Magnet Synchronous Machine for a Hybrid Hydraulic Excavator

Design And Optimizations Of Solenoid Magnetic Structure For Inductive Power Transfer In Ev Applications

Design and Optimization of a Hybrid Excitation System for Magnetically Driven Rotating DC Arc Plasma Generators

High-Frequency High-Density Bidirectional EV Charger

Control Strategy for Electric Vehicle Range-Extender Based on Hybrid Excitation Generator

A Two Stage DC/dc Converter with Wide Input Range for EV

Rapid Calculation and Optimization of Vibration and Noise of Permanent-Magnet Synchronous Motors for EVs Based on Equivalent Structural Network

Design Consideration of Fractional Slot Concentrated Winding Interior Permanent Magnet Synchronous Motor for EV and HEV Applications

Multi-Objective Optimal Design of High-Speed Surface-Mounted Permanent Magnet Synchronous Motor for Magnetically Levitated Flywheel Energy Storage System

Electromagnetic Design And Optimization Of Dual-Stator Brushless Doubly-Fed Wind Power Generator With Cage-Barrier Rotor

Design of A 10 Mw Dual-Stator Superconducting Permanent Magnet Wind Power Generator

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Design and Optimization of Electric Continuous Variable Transmission System for Wind Power Generation

A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator

Multidisciplinary Design and Optimization of High-Speed Hybrid Excitation Starter Generator for Aircraft Power System

Design and Analysis of an Interior Permanent Magnet Synchronous Motor for a Traction Drive Using Multiobjective Optimization

Optimal Design Research of the CPMR for EV with Extended Speed Range