Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

Numerical analysis of supersonic gas-dynamic characteristic in laser cutting

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Modeling and numerical simulation of gas-solid jet in the transitional-rarefied regime

Computational Study of Lateral Jet Interaction in Hypersonic Thermochemical Non-Equilibrium Flows Using Nonlinear Coupled Constitutive Relations

Modeling of the Cutting Front Profile in Abrasive Water Jet Machining Based on the Energy Balance Approach

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Numerical Simulation and Structure Optimization of Compressor Muffler

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Numerical simulation of effect of laser power and assistant gas on laser cutting ability

Numerical Simulation on Dynamic Performance of Assistant Gas During Laser Cutting Process

Visualization of Flow Separation Inside Cut Kerf During Laser Cutting of Thick Sections

Numerical Study on the Effect of a Lobed Nozzle on the Flow Characteristics of Submerged Exhaust

Evaluation and Optimal Design of Supersonic Nozzle for Laser-Assisted Oxygen Cutting of Thick Steel Sections

Research on Influence Mechanism of Nozzle Structure on Properties of Thick Carbon Steel Plate by Laser Cutting

Numerical Analysis of Jet in the Micro-Jet Structure

Modelling Of Impinging Flow And Heat Transfer In A Confined Narrow Gap

Numerical Modeling and Experimental Study on the Material Removal Process Using Ultrasonic Vibration-Assisted Abrasive Water Jet

Numerical investigations of water jet-guided laser cutting of silicon

Impact of Laval nozzle structure on the flow characteristics of supersonic gas-solid two-phase flow

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Flow structure and parameter evaluation of conical convergent–divergent nozzle supersonic jet flows