Abstract:In this communication, we present a low-cost chipless radio frequency identification (RFID) tag with a high data capacity and a wide reading range based on time-domain scattering modulation. The proposed tag consists of a slotted square patch antenna with a switchable resistor and a mechanically driven slider etched with a barcode-like metallic wire array. Encoding is achieved by the presence and absence of the metallic wire on the slider, and tag identification is obtained by sequential bit reading. A special encoding strategy is applied to improve its insensitivity to the motion velocity of the slider. For a proof-of-concept demonstration, a prototype designed to operate at 2.1 GHz was fabricated and measured, and the experimental results verified the effectiveness. Compared with the methods based on time-domain reflectometry, spectral signature, and resonator-based sequential encoding, the proposed approach provides a substantially enhanced data capacity within a narrow spectrum without sacrificing its reading range and tag size, due to the design of nonresonant code cell. Such a mechanically triggered chipless RFID tag exhibits promising potentials in some practical applications, such as personal ID and credit cards.

A Low-Cost UHF RFID Tag Chip with AES Cryptography Engine

A Low-Cost UHF RFID Tag Baseband with an IDEA Cryptography Engine.

Design and Implementation of a Security-Enhanced Baseband System for UHF RFID Tag

A Dual-Mode Secure UHF RFID Tag with a Crypto Engine in 0.13-Μm CMOS

A 180 Nm-Cmos Asymmetric UWB-RFID Tag with Real-time Remote-monitored ECG-sensing

An Implementation of AES for RFID UHF Passive Tag

Implementation of XTEA on UHF RFID Chip

Design and Implementation of an Ultra-Low Power Passive UHF RFID Tag

A DPA-resistant Crypto Engine for UHF RFID Tag

Low-Cost Low-Power Uhf Rfid Tag With On-Chip Antenna

A novel design of secure RFID tag baseband

Design of a UHF RFID tag baseband with the hummingbird cryptographic engine

High Data Capacity Chipless RFID Tag Based on Time Domain Scattering Modulation

ASIC Implementation of Low Power Baseband Processor for UHF RFID Tag

An Ultra Low-Voltage, Low-Power Baseband-Processor for UHF RFID Tag

Design of a low-cost low-power baseband-processor for UHF RFID tag with asynchronous design technique

Design and Implementation of a High Sensitivity Fully Integrated Passive UHF RFID Tag

Design of Analog Front End of Passive UHF RFID Tag

Low Power and High Throughput Authenticated Encryption Chip for Radio Frequency Applications

An Uhf Rfid Transponder with Novel Demodulator and Security Algorithm

An Ultra Low Power Digital Processor for Chinese UHF RFID Transponder