Abstract:Thin‐film rechargeable lithium batteries with amorphous and crystalline LiCoO2 cathodes were investigated. The lithium cobalt oxide films were deposited by radio‐frequency (RF) magnetron sputtering of an LiCoO2 target in a 3:1 Ar/ O2 mixture gas. From proton‐induced γ‐ray emission analysis (PIGE) and Rutherford backscattering spectrometry (RBS), the average composition of these films was determined to be Li1.15CoO2.16 or, within experimental uncertainty, LiCoO2+0.08 Li2O . The x‐ray powder diffraction patterns of films annealed in air at 500 to 700°C were consistent with the regular hexagonal structure observed for crystalline LiCoO2 . The discharge curves of the cells with amorphous LiCoO2 cathodes showed no obvious structural transition between 4.2 and 2.0 V, while the discharge curves of the cells with polycrystalline cathodes were consistent with a two‐phase potential plateau at ∼3.9 V with a relatively large capacity. Two lower capacity plateaus were observed at ∼4.2 and 4.1 V with the 600 and 700°C annealed cathodes; the −dq/dV peaks were broader and weaker for the 600°C annealed cathodes and were not present at all with the 500°C annealed films. The chemical diffusion coefficients of Li+ in the cathodes obtained from ac impedance measurements at cell potentials of ∼4V ranged from ∼10−12 cm2/s for the as‐deposited amorphous cathodes to ∼10−9 cm2/s for the films annealed at 700°C. The capacity loss on extended cycling of the thin‐film cells varied with the crystallinity and thickness of the cathodes and with temperature. With the highly crystalline, 700°C annealed material, losses on cycling between 4.2 and 3.8 V at 25°C ranged from 0.0001%/cycle (>104 cycles) to 0.002%/cycle for cells with cathodes from 0.05 to 0.5 μm thick.

Electrochemical Characterization of Amorphous LiFe(WO4)2 Thin Films As Positive Electrodes for Rechargeable Lithium Batteries

Fe2O3–Ag Porous Film Anodes for Ultrahigh‐Rate Lithium‐Ion Batteries

Nano-sized Copper Tungstate Thin Films As Positive Electrodes for Rechargeable Li Batteries

Electrostatic Spray Deposition of Porous Fe2V4O13 Films As Electrodes for Li-ion Batteries

Nanostructured WO3 thin film as a new anode material for lithium-ion batteries

Non-destructive Chemical Prelithiation of VO2(B) Anodes Constructing a Multifunctional Interphase Layer for Advanced Li-Ion Batteries

Electrostatic spray deposition of porous Fe2O3 thin films as anode material with improved electrochemical performance for lithium–ion batteries

Engineering Wavy‐Nanostructured Anode Interphases with Fast Ion Transfer Kinetics: Toward Practical Li‐Metal Full Batteries

Amorphous Fe2O3 As a High-Capacity, High-Rate and Long-Life Anode Material for Lithium Ion Batteries

LiFe(MoO4)2 as a novel anode material for lithium-ion batteries.

Pulsed laser deposited FeOF as negative electrodes for rechargeable Li batteries

Cobalt Ferrite Thin Films As Anode Material for Lithium Ion Batteries

Physical and Electrochemical Characterization of Thin Films of Iron Phosphate and Nitrided Iron Phosphate for All-Solid-State Batteries

Stable Lithium Deposition Enabled by an Acid-Treated G-C3n4 Interface Layer for a Lithium Metal Anode.

Hierarchically Macroporous and Mesoporous Sponge-Like Fe3O4 Thin Film Electrodes for Application in Li-Ion Batteries

High‐rate Lithium Iron(II) Phosphate as Cathode Material for Rechargeable Lithium Batteries

High‐Rate LiFePO4 Electrode Material Synthesized by a Novel Route from FePO4 · 4H2O

Characterization of Thin‐Film Rechargeable Lithium Batteries with Lithium Cobalt Oxide Cathodes

Characteristics and Electrochemical Performance of LiFe0.5Mn0.5PO4/C Used As Cathode for Aqueous Rechargeable Lithium Battery

Synthesis and Characterization of ZnFe$lt;inf$gt;2$lt;/inf$gt;O$lt;inf$gt;4$lt;/inf$gt; Anode for Lithium Ion Battery

Electrodeposited Carbon@fe2o3 Composites As Binder-Free Anodes for Lithium Ion Batteries