Abstract:A coordination-assisted pyrolysis procedure was adopted to encapsulate palladium (Pd) nanoparticles in a mesoporous carbonaceous matrix. X-ray diffraction and transmission electron microscopy measurements revealed that approximately 2.5 nm nanoparticles were highly dispersed inside the well-ordered porous framework. High-resolution TEM and temperature-programmed hydride decomposition analysis demonstrated the formation of interstitial carbon in the Pd lattice. Diffuse reflectance infrared Fourier transform spectroscopy indicated that carbon species could be deposited on low-coordinated surface sites of the Pd particles. This catalyst exhibited high activity in the selective hydrogenation of cinnamaldehyde (CAL) at 80 degrees C under an H-2 pressure of 1.0 MPa (turnover frequency (TOF) of 2.4 s(-1)) to produce hydrocinnamyl aldehyde with high selectivity (HCAL; approximately 80%) in water and could be reused eight times with no dear activity loss. A trapping agent poisoning experiment using solid SH-SBA-15 revealed unobvious leaching of Pd into the solution. Exposure to thiourea with a S:Pd ratio of 0.1 resulted in slight activity and undetectable selectivity losses over the current catalyst in the selective hydrogenation of CAL at 80 degrees C under an H2 pressure of 1.0 MPa. However, a 50% activity loss was observed for commercial Pd/C. Even after an increase in the thiourea concentration to a S:Pd ratio of 3, the TOF remained at 1.9 s(-1) with a negligible effect on the HCAL selectivity. Nearly complete deactivation of Pd/C occurred upon high exposure to thiourea. DFT calculations showed that the presence of surface or subsurface carbon can enhance the poison tolerance of the encapsulated Pd catalysts. The enhanced hydrogenation activity and strong poison tolerance are consistent with the interpretation that Pd nanoparticles are modified by carbonaceous deposits.

HYDROGEN SULFIDE POISONING OF METHANOL SYNTHESIS Cu-BASED CATALYST(III) EFFECTIVENESS FACTOR OF POISONED CATALYST

HYDROGEN-SULFIDE POISONING OF METHANOL SYNTHESIS CU-BASED CATALYST .3. EFFECTIVENESS FACTOR OF POISONED CATALYST

HYDROGEN SULFIDE POISONING OF METHANOL SYNTHESIS Cu-BASED CATALYST∗(II’) POISONING OF COMMERCIAL CATALYST

HYDROGEN SULFIDE POISONING OF METHANOL SYNTHESIS Cu-BASED CATALYST∗ (I) INTRINSIC DEACTIVATION KINETICS

Effect of Methanol on Catalytic Performance of Hy Zeolite for Desulfurization of Fcc Gasoline by Alkylation

Quantitative Differences in Sulfur Poisoning Phenomena over Ruthenium and Palladium: An Attempt To Deconvolute Geometric and Electronic Poisoning Effects Using Model Catalysts

Mechanism of Sulfur Poisoning to Ru-based Catalysts in Supercritical Water Gasification of Glycerol: from Experiment to Combined DFT and Kinetics Studies

Multicomponent diffusion model for effectiveness factor of porous catalyst (V). Finite element method for effectiveness factors of surface poisoned cylindrical catalyst with equilibrium dead zone

Boundary Conditions for Promotion versus Poisoning in Copper-Gallium-based CO2–to–Methanol Hydrogenation Catalysts

Mechanistic insight into methanol electro-oxidation catalyzed by PtCu alloy

One-dimensional isothermal multicomponent diffusion-reaction model and its application to methanol synthesis over commercial Cu-based catalyst

Insight into Methanol Synthesis from Co2 Hydrogenation on Cu(111): Complex Reaction Network and the Effects of H2o

Thermodynamics of Carbonyl Sulfide Poisoning on F-T Synthesis Catalyst

Rational Design of Poisoning-Resistant Catalyst Based on Γ-Al2o3 for Hydrolysis of Carbonyl Sulfide

POISONING OF IRON CATALYST BY COS IN SYNGAS FOR FISCHER-TROPSCH SYNTHESIS

99/00320 Effect of oxide dispersion in a bifunctional catalyst on the formation of dimethyl ether

Inhibition Effect of Phosphorus Poisoning on the Dynamics and Redox of Cu Active Sites in a Cu-SSZ-13 NH3-SCR Catalyst for NOx Reduction.

Effect of sulfur poisoning on the performance and active sites of Cu/SSZ-13 catalyst

Modeling of catalyst poisoning during hydrogen production via methane steam and dry reforming

Effect of Cu and Zn on the performance of Cu-Mn-Zn/ZrO2 catalysts for CO2 hydrogenation to methanol

Poison Tolerance to the Selective Hydrogenation of Cinnamaldehyde in Water over an Ordered Mesoporous Carbonaceous Composite Supported Pd Catalyst