Abstract:This paper presents a novel and easy‐to‐implement modulation strategy for modular multilevel converters that simplifies both hardware design and application. By setting up a flexible insertion and removal submodule and proposing a capacitor voltage balance algorithm based on duty ratio allocation, the proposed modulation method can allow for the separate design of the Algorithm Unit and the pulse width modulation (PWM) Unit in the hardware, which solves the problem of PWM feedback and reduces the hardware requirement of the trigger system. Moreover, the proposed method can broaden the selection range of processor chips. Modulation strategy plays a key role in the operation of modular multilevel converters (MMC). Although many studies have been carried out on its optimization in MMC, the limitations of hardware implementation are seldom considered. This paper presents a novel and easy‐to‐implement modulation strategy that simplifies both hardware design and application. From the analysis in this paper, the widely‐used modulation methods have the problems of pulse width modulation (PWM) signal feedback and complex carrier configuration in hardware implementation. By setting up a flexible insertion and removal submodule and proposing a capacitor voltage balance algorithm based on duty ratio allocation, the proposed modulation method can allow for the separate design of the Algorithm Unit and the PWM Unit in the hardware, which solves the problem of PWM feedback and reduces the hardware requirement of the trigger system. Moreover, the proposed method can broaden the selection range of processor chips. Finally, a downscaled MMC prototype is built; the proposed method is verified by both simulation and experiment.

The Application of Modulation Arithmetic in LCD Driver

A Study on Correction Systemic Algorithm for LCD Projection Display Color Uniformity

A Method for Linearization of Phase Response Generated in Liquid Crystal Modulator

Review on Pulse-Width Modulation Strategies for Common-Mode Voltage Reduction in Three-Phase Voltage-Source Inverters

Performance Analysis of Asynchronous PWM at Low Carrier Ratios

Study of Pixel and Driving Circuits of OLED on Silicon

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.

Driving Method by Digital Signal for Twisted Nematic Liquid Crystal Display

Display and Drawing Methods for LCD Module

A Liquid Crystal Phase Modulation Technique Based on TFT-LCD Architecture

Control of LCD Module Based on PIC32MX MCU by Using Serial Port

Linearization of periodic phase response for Liquid crystal modulator

A Technique on Driving-pulse Edge-modulation and Its Application in Reducing the Switching Voltage Spike of Power Electronic Device

Improving The Processing Speed Of An Lcd Panel Based Correlator By Using A Multi-Channel Correlation Approach

An 8-Line Addressing LCD Driver Based on Orthogonal Matrix

Driving Module for 17.8 Cm AMOLED

A Wide Load-Range OTA Using a Digitally Assisted Compensating Technique

A novel and easy‐to‐implement modulation scheme for reducing modulation complexity in modular multilevel converter

Driving Scheme Optimization for Electrowetting Displays Based on Contact Angle Hysteresis to Achieve Precise Gray-Scales

Driving Schemes for a-Si and LTPS AMOLED Displays

Design of LCD Driver Chip with 1024-Level Gray Scale and Large Capacitor Load