Abstract:The precise control of nanomaterial microstructure at the atomic level relies on the comprehensive understanding of atomic structural transition during the fabrication process at the atomic level. The phase transition from protonated titanate to TiO2 is a prevalent route to synthesize low dimensional TiO2-based nanomaterials, which exhibit excellent photocatalytic, lithium-ion battery performances, while the detailed phase transition mechanism remains to be clarified due to lack of atomic-level in situ information. Herein, the atomic structural transitions from one-dimensional H2Ti3O7 (HT) to TiO2(B) and anatase TiO2 (TB and TA) nanocrystals were revealed through in situ environmental transmission electron microscopy, which exhibited a two-step phase transition at 200-600 degrees C. (I) H2Ti3O7 to TiO2(B) transition began via an indirect pathway at similar to 200 degrees C: The HT (200) interlayer dehydration occurred firstly with lattice shrinkage; Then TB discretely nucleated at the dehydrated H2Ti3O7 nanotube wall with a crystallographic relationship of (200)(HT)parallel to(200)(TB) {[001](HT)parallel to[001](TB)}; At higher temperature, the separated nuclei grew up with defects and distorted crystal lattice among them, which then connected and jointed to a single crystalline TB nanotube by atomic rearrangement. (II) The further transition of TiO2(B) to anatase TiO2 occurred via a direct pathway above 400 degrees C: Scarce nucleation event of TA phase was observed, which generated within TB nanocrystal with a crystallographic relationship of (200)(TB)parallel to(002)(TA) {[001](TB)parallel to[010](TA)}. Once a TA nucleus formed, it grew up to a large crystal by consuming the neighbor TB nanocrystals. These findings may contribute to comprehensively understanding phase transition and precisely manipulating the atomic structure of one-dimensional TiO2 nanocrystals.

Converting Industrial TiO2 into Titanate Nanotubes by Simple Sonochemical-Hydrothermal Processing

Preparation and characterization of titanium oxide nanotubes

Preparation and Photocatalytic Activities of TiO2 Nanotubes with Mixed Crystal Structure

Rapid-Heating-Triggered in Situ Solid-State Transformation of Amorphous TiO2 Nanotubes into Well-Defined Anatase Nanocrystals

Low-temperature preparation of titania nanorods through direct oxidation of titanium with hydrogen peroxide

Facile Synthesis of Ni-doped TiO2ultrathin Nanobelt Arrays with Enhanced Photocatalytic Performance

Direct Continuous Hydrothermal Synthesis of High Surface Area Nanosized Titania

Controlling the Synthetic Pathways of Tio2-Derived Nanostructured Materials

Preparation of high active nanometer TiO2 sonocatalyst by partial transition crystal in hydrogen peroxide solution under ultrasonic irradiation

Control of Microscopic Morphology and Structure of One Dimensional Titanium Dioxide Nanomaterials

Nanocrystalline Titania Made From Interactions Of Ti With Hydrogen Peroxide Solutions Containing Tantalum Chloride

In Situ Revealing the Dehydration and Atomic Structure Evolution of Protonated Titanate Nanotubes Via Environmental Transmission Electron Microscopy

Dissolution/recrystallization Growth of Titanate Nanostructures by Amorphous Precursor

Synthesis of Sodium Titanate Nanotubes by Microwave Hydrothermal Method

Characterization, Properties and Catalytic Application of TiO2 Nanotubes Prepared by Ultrasonic-Assisted Sol-Hydrothermal Method

Synthesis of One-Dimensional Sodium Titanate Nanostructures.

Enlarging the application of potassium titanate nanowires as titanium source for preparation of TiO 2 nanostructures with tunable phases

Topotactic conversion route to ultrafine crystalline TiO2 nanotubes with optimizable electrochemical performance

Preparation, characterization and applications of titanate/titania nanocrystals

From Titanates to TiO 2 Nanostructures:Controllable Synthesis,growth Mechanism,and Applications

Large-Scale Synthesis and Characterization of TiO2-Based Nanostructures on Ti Substrates