Application Of Sma Wire Actuators In Flatness Control Of Membrane Sarantennae
Fujun Peng,Yan-Ru Hu,Xin-Xiang Jiang,Alfred Ag
2009-01-01
Abstract:A membrane SAR(Synthetic Aperture Radar) antenna will be subjected to flatness problems during its lifetime in orbit due to the thermal variations in space. A pure passive control method may not be sufficient to maintain the membrane's flatness since the thermal loads are changing. Therefore, an active control system, which is used to adjust the tensions according to the thermal variations, is developed. SMA wire actuators are selected to exert required tension, due to their unique properties such as high force, long stroke, small size, light weight, and silent operation, etc.First, the selected SMA wire actuators are tested in the ambient air environment as well as in a vacuum chamber to characterize their stability and controllability properties. Tests are conducted under a constant load and variant input currents are used to activate the actuator. The results indicate that, in the ambient air environment, the displacement outputs of the SMA actuator are not stable if the full phase transformation is not achieved. This clearly reflects the influence of the natural air convection on the stability of the actuation. As a contrast, the displacement Outputs of the SMA in the vacuum condition are much more stable at all given input currents. This implies that SMA actuators probably can be used directly in space without any assistance of control strategy. However, it is also noticed that, in vacuum environment, it mostly takes much more time to achieve a stable displacement output, and in some cases even more than 20 minutes are needed. This may limit SMA's application in space if no other means is utilized to increase its response speed.To overcome SMA's poor stability and increase its response speed, an actuator control strategy is developed based on the idea of adjusting the SMA wire temperature as fast as possible. This strategy is simple, stable, and no hysteresis model or thermal model is required. Tests are performed and the results demonstrated that the proposed control strategy is very effective in controlling SMA actuators. Under this control strategy, SMA wire actuator can track square wave, ramp, and sinusoidal signal with very high accuracy - small steady error and overshoot. By increasing the input current, SMA response speed can be increased remarkably. In spite of an increase of rising overshoot and possibly the RMS error, the absolute values of them are still very small. It is also indicated that shorter sampling interval is helpful in getting higher tracking accuracy.After getting the above testing results with satisfactory accuracy, the actuator control strategy is integrated into a control system based on genetic algorithm, and used to control the flatness of a membrane SAR antenna model. Tests are performed 20 times at room temperature. Each time all tension combinations generated by the genetic algorithm are very well realized by the SMA actuators and the standard deviation of the membrane flatness goes down quickly from around 0.22mm to less than 0.05mm. Another 20 tests are then performed with local thermal load applied. Again optimal tension combinations are realized very well. The membrane flatness goes down quickly from around 0.33mm to less than 0.05mm.