Numerical Simulation on Water-Inrush from the Seam Floor Based on the Coupled Analysis of Seepage and Damage

Qi-yan FENG,Tian-hong YANG,Qing-lei YU,Chun-an TANG,Xue-feng LENG
DOI: https://doi.org/10.3969/j.issn.1009-6094.2006.03.001
2006-01-01
Applied Mechanics and Materials
Abstract:The present paper aims to introduce the authors' simulation of the instable failure process of seam floor above confined aquifer under mining. Our simulation was done numerically based on the theory of the flow and damage coupling by using F-RFPA 2D (Coupling System of Flow Solid in Rock Failure Process Analysis). The paper also made a discussion with F-RFPA 2D the water outburst mechanism from the seam floor and predicted the position of the water outburst. In accordance with the geological conditions of Yangcun coalmine, a mechanical model for the mining process simulation of seam No.17 with average height of 1.2 m was established. The simulation results show that, when the coal of 26.8 m long was mined, the failure zone caused by the shear and tension was developed due to the water retarding formation as well as other factors concerned in the nearby zones. Then the failure zone would gradually perforate into the underlying confined aquifer, which in turn may lead to the water outburst. In such a situation, the displacement and flow volume would increase suddenly after the water outburst. Statistically the vertical flow proved to be 650 m3/(d·m) with the displacement being 700 mm. The maximum depth of the failure zone reached 13 m below the seam. And in turn the failure would also cause water-inrush from the karst aquifer No.12 and No.13 but might not be linked to karst aquifer No.14 and Ordovician system. In such a case, the aquifer No.14 and Ordovician system would usually turn to be the major threat to seam No.17. As a matter of fact, the water-pressure test with Yangcun Coalmine before and after the coal excavation was designed with its two working faces, whose results indicate that the maximum fractured depth has reached 12.35 m under the seam floor. The given result is actually consistent with that of the numerical simulation. Therefore, F-RFPA 2D can be used in predication of water-inrush in coalmining.
What problem does this paper attempt to address?