Electrohydrodynamic atomization of a C nano-suspension

Duan Hongbin,Wang Dazhi,Liang Junsheng,Liu Chong
DOI: https://doi.org/10.3969/j.issn.2095-2783.2010.08.002
2010-01-01
Abstract:6% C nano-suspension was atomized using electrohydrodynamic atomization (EHDA) technique; the C nano-suspension is the key material for the formation of the micro-porous layer (MPL) of gas diffusion layer (GDL) which is a major part of membrane electrode assembly (MEA) of proton exchange membrane fuel cells (PEMFC). The different atomization modes and the condition for the formation of stable cone-jet mode were studied. In the stable cone-jet mode, the effect of the atomization parameters (applied voltage, flow rate and working distance) on size and distribution of the deposited droplets and structure of the films were examined. The results showed that the flow rate and working distance had strong influence on the size and distribution of the droplets, while the applied voltage was inconspicuous. The higher flow rate and working distance resulted in dense deposited droplets, which is mainly at the range of 0.2 μm to 0.4 μm. C films were also deposited using C nano-suspension and EHDA technique in stable cone-jet mode at different working distance. At a greater distance dense C films were produced, at a smaller distance porous C films were generated. Based on this research, this work presents a method for the formation of MPL and DL of PEMFC.
What problem does this paper attempt to address?