Abstract:In the calculation of process dimensions in the machining of porous parts, the traditional method is complicated in the establishment of the dimensional chain, it is easy to make mistakes in the judgment of increasing and decreasing loops, and there is difficulty in the calculation process; thus, this paper puts forward a method that combines the process path with the design path to analyze the hole system dimensions in response to these problems. First of all, the combination of the process path and design path is used to establish a system of vector equations and, according to the system of vector equations, to establish a matrix model to calculate the process dimensions based on the system of vector equations to construct the process dimensional chain and the dimensional chain function; then, the principle of differentiation is used to carry out a tolerance analysis of the process dimensions, which avoids the drawing of dimensional chain diagrams and the judgement of the incremental/decremental loops. Finally, the development of a process dimension analysis tool for hole system dimensions is completed based on CATIA CAA. In order to verify the effectiveness of the proposed method, the analysis tool was used to solve the three labeling methods of the hole system dimensions of porous parts and compared with the results calculated using the traditional method, and it was found that some of the tolerance results obtained by the proposed method were enlarged by about 50%, which is more in line with the actual production situation. Finally, in order to verify the accuracy of the tool's calculation results, three porous parts were machined according to the process dimensions and tolerances calculated by the tool, and the center distance of each hole was measured by a coordinate meter. These measurements were compared and analyzed with the design dimensions specified in the engineering drawings, and it was found that the center distances of the holes were in full compliance with the design requirements.

Computer Solution of Process Size on the Base of Graphic Tracing Method

Point-based Geometric Model Applied to CAD/CAM

Computer Solution of the Radial Process Size of the Rotational Parts in the CAPP System

A Novel Hole System Dimension Analysis Tool Based on the Combination of the Process Path and Design Path

Research on the Algorithm of Technological Dimension Chain Based on 3d Process Models

Manufacturing Error Modeling Based on Homogeneous Transformation

A feedback toolpath generation method for compound trimmed surface with machine’s dynamic characteristics confined

A New Approach to Design Geometric Dimensioning & Tolerancing

An automatic generation approach of process model based on feature knowledge and geometric modeling

Operational Dimension Calculation by Computer

Application of Graphical Method for Measurement Data Processing Based on CAD

Digital Methods of Complex Product Manufacturing Precision Control and Its Development Trend

The Size Effects on Process Design of Micro Deep Drawing

The research and application of three dimensional complex size detection

Dimension Technology in CAD System of Plain Bearing of Internal Combustion Engine

Simulation Verification of Parts Processing Based on Virtual Numerical Control Machine

Research on Theory of Obtaining Three-dimensional Size about Entity from Mechanical Parts Photos

The VFP-based Computer-aided Determine of Gear Teeth Number in the Variable Speed Group of Machine Tools

Size effects on process design of micro deep drawing

Configuration of Process Planning Based on Lot-Size Gene

MBD-Based Machining Feature Recognition and Process Route Optimization