Abstract:The use of poly(vinylidene fluoride) (PVDF) microfiltration (MF) membranes to purify oily water has received much attention. However, it is challenging to obtain high-performance PVDF microfiltration membranes due to severe surface fouling and rapid decline of permeability. This study explored a new approach to fabricate high-performance PVDF/silica (SiO2) composite membrane via the use of a polymer solution featuring lower critical solution temperature (LCST) characteristics and the non-solvent thermally induced phase separation method (NTIPS). Coupling with morphological observations, the membrane formation kinetics were analyzed in depth to understand the synergistic effect between the LCST solution properties and fabrication conditions in NTIPS. Utilizing such a synergistic effect, the transition from finger-like macrovoid pores to bi-continuous highly connected pores could be flexibly tuned by increasing the PVDF concentration and the weight ratio of SiO2/PVDF in the dope solution and by raising the coagulation temperature to above the LCST of the solution. The filtration experiments with surfactant-stabilized oil-water emulsion showed that the permeation flux of the PVDF/SiO2 composite membranes was higher than 318 L·m−2·h−1·bar−1 and the rejection above 99.2%. It was also shown that the PVDF/SiO2 composite membranes, especially those fabricated above the LCST, demonstrated better hydrophilicity, which resulted in significant enhancement in the anti-fouling properties for oil/water emulsion separation. Compared to the benchmark pure PVDF membrane in oily water purification, the optimal composite membrane T70 was demonstrated via the 3-cycle filtration experiments with a significantly improved flux recovery ratio (Frr) and minimal reduced irreversible fouling (Rir). Overall, with the developed method in this work, facile procedure to tune the membrane morphology and pore structure was demonstrated, resulting in high performance composite membranes suitable for oil/water emulsion separation.

Experimental Study on Revolving Cross-flow Microfiltration of Highly Viscous Liquids

Effect of solvent concentration on development of macrovoids of PVDF phase-diversion membranes

Finite Volume Method of the Microfiltration of Viscoelastic Polymer Solution

High flux positively charged nanofiltration membranes prepared by UV-initiated graft polymerization of methacrylatoethyl trimethyl ammonium chloride (DMC) onto polysulfone membranes

Fabrication and Performance of a Low Operating Pressure Nanofiltration Poly(vinyl Chloride) Hollow Fiber Membrane

Effects of solvent compositions on physicochemical properties and anti-fouling ability of PVDF microfiltration membranes for wastewater treatment

An experimental and modeling investigation of the behaviors of solution in fluoropolymers hollow fiber membranes (HFMs)

Study on Preparation and Performance of Modified Polyvinyl Chloride-co-vinyl Acetate Microfiltration Membranes

Influence of the pectin and cellulose on the performance of cross-flow microfiltration

Separation of Oil/water Emulsion Using Nano-Particle (tio(2)/al(2)o(3)) Modified PVDF Ultrafiltration Membranes and Evaluation of Fouling Mechanism.

A Facile Method to Control Pore Structure of PVDF/SiO2 Composite Membranes for Efficient Oil/Water Purification

Study on the Modification of PVDF Membrane (1) Preparation of Hydrophilic PVDF Hollow Fiber Membrane with PVP Via Cross-Linking Reaction

Technical Concepts for the Investigation of Spatial Effects in Spiral-Wound Microfiltration Membranes

Ingredient-Wise Study of Flux Characteristics in the Ceramic Membrane Filtration of Uncontaminated Synthetic Metalworking Fluids, Part 2: Analysis of Underlying Mechanisms

Design of a novel PVDF-HFP/GE tubular nanofiber membranes for ultrafast and continuous oil/water separation

Analysis of microfiltration performance with constant flux processing of secondary effluent

Natural organic matter fouling of microfiltration membranes: Prediction of constant flux behavior from constant pressure materials properties determination

Effects of crossflow velocity and transmembrane pressure on microfiltration of oil-in-water emulsions

Preparation of high-flux polyethylene hollow fiber microfiltration membranes with multiple pore structure through the combination technology of braided tube reinforcement and TIPS method

Ultrafiltration modeling of non-ionic microgels

Sludge Components and Their Fouling Properties in a Submerged Micro-Membrane Filtration System