Abstract:One of the major challenges in applying membrane technology is how to mitigate fouling, which decreases membrane productivity and lifetime. We previously developed a technique for preparing thin-film composite (TFC) polyamide membranes with submicron-patterned surfaces (via nanoimprint lithography), using interfacial polymerization techniques consistent with those used in the commercial production of reverse osmosis membranes. Herein, we present results from crossflow permeation experiments with these patterned and non-patterned TFC membranes using aqueous NaCl/glycerol solutions, with and without bovine serum albumin (BSA) as a model protein foulant. The NaCl/glycerol/water fractionation properties of these membranes were not significantly affected by the imprinting process, and their separation performance is similar to that of commercially available materials. At a low transmembrane pressure with operation likely experiencing weak concentration polarization, the permeance decline is small with both imprinted and non-imprinted membranes. At a higher transmembrane pressure, however, a rapid flux decline was observed for the non-patterned membranes but not for the patterned ones. Furthermore, the patterned membranes recovered more of their initial pure water permeance after the fouling permeation experiments. These initial findings reinforce the prospect of improved long-term fouling mitigation due to surface patterning. In particular, our results suggest that even regular ~30nm protruding surface patterns increase the flux with low protein deposition and may also lead to a looser structure (and, thus, easier removal) of any deposited surface protein layer.

Ingredient-Wise Study of Flux Characteristics in the Ceramic Membrane Filtration of Uncontaminated Synthetic Metalworking Fluids, Part 2: Analysis of Underlying Mechanisms

Influence of Ceramic Membrane Surface Characteristics on the Flux Behavior of a Complex Fermentation Broth

Simulation Study on Mitigating Permeate Flux Decline with Electroosmotic Flux in Dead-End Ultrafiltration Process

Microscopic Mechanism Of Membrane Fouling In Micro-Filtration

Analysis of microfiltration performance with constant flux processing of secondary effluent

Critical flux of surface-patterned ultrafiltration membranes during cross-flow filtration of colloidal particles

Relating critical and limiting fluxes to metastable and long-term stable fluxes in colloidal membrane filtration through collision-attachment theory

Monitoring Membrane Fouling Using Fluid Dynamic Gauging: Influence of Feed Characteristics and Operating Conditions

Comparison of membrane fouling during ultrafiltration with adsorption studied by Quartz crystal microbalance with dissipation monitoring (QCM-D)

Comparison of fouling mechanisms in low-pressure membrane (MF/UF) filtration of secondary effluent

Natural organic matter fouling of microfiltration membranes: Prediction of constant flux behavior from constant pressure materials properties determination

A transient biological fouling model for constant flux microfiltration

Fractionation and Flux Decline Studies of Surface-Patterned Nanofiltration Membranes Using NaCl-glycerol-BSA Solutions

Use of Nanoimprinted Surface Patterns to Mitigate Colloidal Deposition on Ultrafiltration Membranes

The Fouling Effect on Commercial Ceramic Membranes during Filtration of Microalgae Chlorella vulgaris and Monoraphidium contortum

Stabilization of flux during dead-end ultra-low pressure ultrafiltration

Preparation of Low-Cost Silicate-Based Microfiltration Membrane: Characterization, Membrane Fouling Mechanism and Antifouling Performance

Super‐hydrophilic Electrospun PVDF/PVA‐blended Nanofiber Membrane for Microfiltration with Ultrahigh Water Flux

New Insights into the Fouling of a Membrane during the Ultrafiltration of Complex Organic–Inorganic Feed Water

Development of membranes with low surface energy to reduce the fouling in ultrafiltration applications

Hydrophilic Fe2O3 Dynamic Membrane Mitigating Fouling of Support Ceramic Membrane in Ultrafiltration of Oil/water Emulsion