Abstract:Springback has always been a stubborn defect that affects the axial accuracy of metal bending. The finite element simulation of springback enables effective control and precise compensation to improve the forming quality. Affected by the material, size, and forming process, the generation pattern of the springback defect remains further exploration. Graph-based deep learning techniques support differentiable high-dimensional physics simulations with significantly lower computational resources and comparable accuracy. In this paper, a framework based on geometry/process-integrated Graph Neural Networks (GNN) is presented for simulating axial springback of mesh-based metal bending, with a specific focus on the tube bending. The framework adopts an encode-process-decode structure, equipped with parallel graph network blocks and data augmentation strategy, to capture the axial springback information with high fidelity in a form of mesh. Comparative experiments reveal that our framework achieves an accuracy comparable to that of finite elements method, yielding an average nodal error below 1 mm and outperforming three representative GNN baselines. The framework remarkably enhances the simulation efficiency, exhibiting a four-order-of-magnitude improvement on CPU and a six-order-of-magnitude improvement on GPU compared to finite elements method. Furthermore, we successfully apply the proposed framework to simulate the springback of plate V-bending, showcasing its robust generalization ability. These results illustrate the capability of our GNN framework to achieve the accurate and real-time springback simulation, with significant implications for digital twin development and bent tube quality optimization.

FEM Simulation for the Bending Spring-Back of Thin-Walled and Large Diameter Tube

Springback Analysis for Warm Bending of Titanium Tube Based on Coupled Thermal-Mechanical Simulation

Springback prediction of titanium tube bending considering Bauschinger effect and Young's modulus variation

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Analysis of Springback Characteristics of Bending Unloading for Stainless Steel tubes

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Springback law of high-strength 21-6-9 stainless steel tube in numerical control bending under different process parameters

Forming method and cross-section deformation of transition section of finned special-shaped tubes in 3D free bending technology

Spatial variable curvature metallic tube bending springback numerical approximation prediction and compensation method considering cross-section distortion defect

Push-bending Process of Stainless-Steel Tubes: Experiment and Simulation

Springback Prediction Model Considering the Variable Young’s Modulus for the Bending Rectangular 3A21 Tube

Finite Element Analysis and Design in Stainless Steel Sheet Forming and Its Experimental Comparison

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Spiral forming and cross-section deformation behaviors of finned special-shaped tube

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Behavior of Thin-Walled Dodecagonal Section Double Skin Concrete-Filled Steel Tubes under Bending

Numerical Simulation of Distortion of Rectangular Tube with Multi-Point Stretch Bending

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Finite Element Analysis of Seamless Steel Tube NC Bending

Towards high-accuracy axial springback: Mesh-based simulation of metal tube bending via geometry/process-integrated graph neural networks