Determination of Tracer Gas Contents in Sediment Pore Water of Gas Hydrate Area by Two-Dimensional Gas Chromatography

Wang Hu,Yang Qunhui,Ji Fuwu,Zhou Huaiyang,Xue Xiang
DOI: https://doi.org/10.3724/sp.j.1123.2011.00070
2011-01-01
Abstract:A two-dimensional gas chromatographic instrument was established by the capillary flow technology (Deans Switch) and two columns (PoraPLOT Q and Molsieve 5A) and three detectors (pulsed discharge helium ionization detector, flame photometric detector and thermal conductivity detector). The instrument can be used to measure tracer gases simultaneously including hydrogen, methane, carbon dioxide and hydrogen sulfide. The detection limits of the hydrogen, methane, carbon dioxide and hydrogen sulfide were 0.51, 0.17, 82 and 0.08 micromol/mol, and the calibration curves presented good linear relationships in the range of 2-1030, 0.6-501, 120-10500 and 0.2- 49.1 micromol/mol, respectively. The relative standard deviations were less than 10% for the measurements of ten standard gases. By this method, the tracer gases in the sediment pore water of gas hydrate area in South China Sea had been detected. This method is simple, sensitive, and suitable for on-board detection. Compared with the usual methods for measuring tracer gases, the amount of a sample necessary is reduced greatly. It is useful for the survey of gas hydrate and hydrothermal resources below sea floor and for the research of dissolved gases in the ocean.
What problem does this paper attempt to address?