Abstract:A stainless steel wire was immersed in a hydrophobic ionic liquid (IL, i.e. 1-octyl-3-methylimidazolium hexafluorophosphate), then was heated under an infrared lighter to make the viscous IL form an even and reproducible film on the steel wire. After that polyaniline (PANI) was electrodeposited on it from an aqueous solution containing 0.1 mol.L-1 aniline and 1.0 mol.L-1 HNO3 through cyclic voltammetry. The potential range was -0.2 similar to 1.2 V (vs. saturated calomel electrode, SCE), the scan rate was 50 mV.s(-1) and the cyclic potential scan was repeated for 70 times. For the electrodeposition a conventional three-electrode system was adopted, including the IL; coated stainless steel wire as working electrode, a platinum wire as counter electrode and a saturated calomel electrode as reference electrode. The resulting PANI-IL composite coating was rinsed with methanol and distilled water. Following this, it was conditioned in a electric furnace with nitrogen atmosphere at 90 degrees C for 30 min, at 250 degrees C for 150 min. When the obtained fiber was cool, it was fixed on a home-made device for solid-phase microextraction (SPME) with epoxy resin. The coating showed netlike structure, with smaller hole and larger surface area than that of PANT. Taking several phenolic derivatives (i.e. 2-chlorophenol, 2-methylphenol, 2,6-dimethylphenol, 2,4-dimethylphenol and 3-methylphenol) as models, the analytical performance of the fiber was investigated. Under the optimized conditions (i.e. extraction temperature: 60 degrees C; extraction time: 40 min; stirring rate: 600 r/min; NaCl concentration: 0.35 g.mL(-1); desorption time: 3 min; desorption temperature: 250 degrees C), when the phenols were determined by GC after headspace solid-phase microextraction with the fiber, the linear ranges were 0.048 similar to 400 mu g.L-1 with correlation coefficients above 0.99; the detection limits were 61 similar to 98 ng.L-1 (S/N=3). The relative standard deviations (RSD) of chromatographic peak area were smaller than 5.5% for five successive measurements with single fiber, and the fiber to fiber RSD was 3.7%similar to 12% for different phenols (n=3). The fiber also presented good stability and its extraction efficiency kept almost unchanged after being used for about 150 times; when the temperature was up to 300 degrees C it did not decompose. In comparison with PANT fiber, the PANI-IL fiber showed higher extraction capability. The PANT-IL fiber was successfully applied to the determination of phenols in waste water from a chemical factory.

A Novel Fluorinated Polyaniline-Based Solid-Phase Microextraction Coupled with Gas Chromatography for Quantitative Determination of Polychlorinated Biphenyls in Water Samples.

Determination of 16 Polycyclic Aromatic Hydrocarbons in Water Using Fluorinated Polyaniline-Based Solid-Phase Microextraction Coupled with Gas Chromatography

Polyaniline/cyclodextrin composite coated stir bar sorptive extraction combined with high performance liquid chromatography-ultraviolet detection for the analysis of trace polychlorinated biphenyls in environmental waters

Determination of phthalates in water samples using polyaniline-based solid-phase microextraction coupled with gas chromatography.

Analysis of chloro- and nitrobenzenes in water by a simple polyaniline-based solid-phase microextraction coupled with gas chromatography.

Preparation and Applications of Perfluorinated Ion Doped Polyaniline Based Solid-Phase Microextraction Fiber.

Solid-phase Microextraction Based on Polyaniline Doped with Perfluorooctanesulfonic Acid Coupled to HPLC for the Quantitative Determination of Chlorophenols in Water Samples.

Stainless steel fiber coated with poly(1-hexyl-3-vinylimidazolium) bromide for solid-phase microextraction of polychlorinated biphenyls from water samples prior to their quantitation by GC

Porous aromatic framework/polydimethylsiloxane coated stir bar sorptive extraction coupled with high performance liquid chromatography-diode array detection of trace polychlorinated biphenyls analysis in environmental waters.

Nano-structured Polyaniline-Ionic Liquid Composite Film Coated Steel Wire for Headspace Solid-Phase Microextraction of Organochlorine Pesticides in Water.

Electrochemical Preparation of Polyaniline-Ionic Liquid Based Solid Phase Microextraction Fiber and Its Application in the Determination of Benzene Derivatives

Analysis of Polychlorinated Biphenyls in Biological Samples by Headspace Solid Phase Microextraction Coupled with Gas Chromatography

Polyaniline-Based Fiber for Headspace Solid-Phase Microextraction of Substituted Benzenes Determination in Aqueous Samples

Solid Phase Extraction with Silicon Dioxide Microspheres for the Analysis of Polychlorinated Biphenyls in Environmental Water Samples Prior to Gas Chromatography with Electron Capture Detector

Electrodeposition of Porous Polyaniline Coating on an Etching Stainless Steel Wire As A Fiber for Solid-Phase Microextraction of Triclosan and Chlorophenols in Water Samples

Nitrogen-rich carbon nitride as solid-phase microextraction fiber coating for high-efficient pretreatment of polychlorinated biphenyls from environmental samples

Electrochemical Fabrication of Hydrophobic Ionic Liquid–Polyaniline Composite Coating for Solid-Phase Microextraction and Its Application in the GC Determination of Phenolic Compounds

Electrodeposited Polyaniline As A Fiber Coating for Solid-Phase Microextraction of Organochlorine Pesticides from Water

Headspace solid-phase microextraction with self-prepared polyaniline coating for rapid determination of trace polybrominated diphenyl ethers (PBDEs) in water and milk

Metal Organic Nanotubes-based Dispersive Solid Phase Extraction-Gas Chromatography-Tandem Mass Spectrometry for SensitiveAnalysis of Polychlorinated Biphenyls in Environmental Water Samples

Polyaniline-coated kapok fibers for convenient in-syringe solid-phase microextraction and determination of organochlorine and pyrethroid pesticide residues in aqueous samples