Abstract:A major problem with the evaluation of surface deflection is that panels are evaluated manually and to a great extent subjectivity is involved. For further study on surface deflections such as process optimization, it is necessary to evaluate the defect objectively and quantitatively. In this paper, quantitative analysis of surface deflections in the automobile exterior panel is carried out based on a curvature-deviation method. The curvature-deviation method uses the deviation-based indicators to quantify the surface deflection and uses the local curvature information to filter defect points in evaluation algorithm. In order to verify the effectiveness of the proposed evaluation method, sample panels with a door handle feature are stamped and measured in experiment. The sample panels are made of different materials and are formed under various blank holder forces. A stylus instrument is used to measure eight representative sections in the sample panel. The measurement result is analyzed in a program based on the curvature-deviation method. We also use the oil stoning method to make a subjective evaluation on surface deflection in the sample panel. By analyzing some verification curves and comparing the evaluation results based on the curvature-deviation method with the experimental oil stoning results, it is verified that the proposed curvature-deviation method can analyze the surface deflection accurately and has a good consistency with the stoning-based subjective evaluation method. In addition, the proposed method is applied to analyze the critical values of surface deflection and the influence of blank holder force on surface deflection. The proposed method to quantify surface deflections is beneficial to process optimization, material selection and tool design for automobile exterior panels.

Engineer Design Method for Automotive Outer Panel Stiffness

Reason on Influencing Automotive Outer Surface Stiffness and Optimization Methods

Modified Fourier-Galerkin Solution For Aerospace Skin-Stiffener Panels Subjected To Interface Force And Mixed Boundary Conditions

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Design And Research Of Stiffness Instrument For Automotive Panel

End Stiffness Modeling for Automatic Horizontal Dual-Machine Cooperative Drilling and Riveting System

Study on the influence factors for surface low of exterior auto-panels

Sensitivity analysis of forming process parameters for car door inner panel

Design and research for automotive panel stiffness instrument based on UG

Optimized structure design of portable stiffness testing instrument

Analysis and Control of Car Door Inner Panel Forming Fracture Based on Experience Knowledge and Numerical Simulation

A study on formability analysis and technological design of outer panels for rear wheel housing on a vehicle

Quantitative Analysis of Surface Deflections in the Automobile Exterior Panel Based on a Curvature-Deviation Method

Optimum Design of an Automotive Inner Door Panel with A Tailor-Welded Blank Structure

Stamping Process Optimization for the Rear Part of Door Inner Pane(lContinued 1)

Analysis and optimization of drawing process for interior car door panel

Structural Finite Element Analysis of the Fixed Stiffness Testing Instrument

The Stiffness and Buckling Behavior of Panels with Stamping-Induced Imperfections

Experiment study on the stiffness of hyperboloid shallow shell of autobody

Dynamic design of stiffeners for a typical panel using topology optimization and finite element analysis

Research of the Influential Factors of the Stifiness and Dent Resistance of High-strength Steel Body Covers