Abstract:The ability to model the cyclic behavior of low yield point steel accurately is essential for its application to seismic design. In this study, uniaxial tests of monotonic and strain controlled cyclic loading are conducted to investigate the mechanical properties of the low yield point steel BLY160. As observed in the test, work-hardening is an important hysteretic characteristic, which significantly influences the energy dissipation capacity of the steel. However, the cyclic softening in both stiffness and stress evolve as the plastic strain accumulates, which is manifested in the decrease of both the stress amplitude and the elastic domain of the stress–strain hysteresis loops. This change in the shape of the cyclic loops is called the “flattening effect” in this paper. To describe the cyclic hardening and softening effect by using one unified set of material parameters, a more sophisticated model based on the concept of internal variables is proposed as an extension of the combined isotropic-kinematic hardening model. The novel idea of a “transformation zone” with the introduction of an additional internal variable is proposed to synchronize the updates of isotropic and kinematic hardening such that the simultaneous change in the stress amplitude and the elastic region can be reproduced. Note that the cyclic softening develops in three stages: incubation, growth and the stabilization period. The logistic function, which presents a curve with an “S” shape, is first used to trace the evolution of the softening. Finally, the model parameters are identified by the test data, and the accuracy of the proposed model is verified by comparing the simulated performance and the experimental response under different loading histories. The results demonstrate that the extended model can elaborately describe the evolutional processes of cyclic hardening and softening by incorporating characteristics, such as the nonlinear transient behavior from elastic to plastic status, early yield under reversed loading and strain history dependence.

Latent Hardening in Aluminium Single Crystals under Cyclic Loading

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Secondary Hardening and Dislocation Evolution in Low Cycle Fatigue of Polycrystalline Aluminium

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

Cyclic Deformation Behavior of A Heat-Treated Die-Cast Al-Mg-Si-Based Aluminum Alloy

Deformation of age-hardened aluminium alloy crystals—I plastic flow

Dynamic Precipitation During Cyclic Deformation of an Underaged Al–Cu Alloy

Cryogenic Deformation Behaviour of Aluminium Alloy 6061-T6

Mg-3Al-1Zn alloy deformed along different strain paths: Role of latent hardening

Deformation of age-hardened aluminium alloy crystals—II. Fracture

Ex-situ EBSD investigation of the reduced c/a values and work hardening behavior in Mg-4Li-1Al-0.5Y alloy under hot compression

Atomic structure of clusters and GP-zones in an Al-Mg-Si alloy

Strain Hardening under Large Deformation for AA5182

Experimental Investigation and FE Analysis on Constitutive Relationship of High Strength Aluminum Alloy under Cyclic Loading

Hardening-softening of Al 0.3 CoCrFeNi high-entropy alloy under nanoindentation

Temperature-Induced Variations in Slip Behavior of Single Crystal Aluminum: Microstructural Analysis

Cyclic Softening Behaviors of Modified 9–12%cr Steel under Different Loading Modes: Role of Loading Levels

Cyclic Deformation and Lattice Strain Distribution of High Nb Containing TiAl Alloy

Precipitation Evolution of Al–Zr–Yb Alloys During Isochronal Aging

Cyclic Hardening and Softening Behavior of the Low Yield Point Steel BLY160: Experimental Response and Constitutive Modeling

Modelling the Effect of Room Temperature Storage and Deformation on the Age-hardening Behaviour of Al-Mg-Si alloys