Abstract:Slewing bearings generally consist of the rotational connection between two substructures for combined load at very low speeds. Although there are a large number of traditional or modern techniques widely used in slewing bearing, they may not be able to meet the requirements of bearing industry precisely due to the huge difference between the general bearing and the slewing bearing, thus, the experiments are the most effective and reliable methods. In this paper a special test machine for slewing bearing is presented and an accelerating fatigue life test method based on the test equipment is proposed to predict the whole fatigue life of the slewing bearing. A virtual instrument test system using vibration detection whose hardware was constructed by signal conditioning, data acquisition card and the industrial personal computer was built. Its software platform was based on LabVIEW. Then the hardware configuration, the sensor mounting arrangement and the use of structured and modular approaches to software programming are described. It is shown that the presented test equipment can meet the high reliability requirements of the fatigue life test for slewing bearing under the actual working conditions.

Development of Measurement and Control System of Crank Fatigue-Test Equipment Based on Lab VIEW

Development Of Automatic Vibration Calibration System

Design of automatic hydraulic test bench based on LabVIEW

The Design of Control Software in Vibration Calibrate System

Automatic Testing and Control System for Electro-Hydraulic Proportional Displacement Pump Based on LabVIEW

Development and Application of Steam Turbine Vibration Sensor Fault Diagnosis and Calibration Instrument

Measuring and Controlling System of the Accelerated Bearing Life Tester with Auto-loading

Design and Development of Test and Control System for Hydraulic Steering Control Unit Based on Virtual Instrument

Monitor System of Energy-Feedback Electronic Load Based on CAN Bus and LabVIEW

Design of Fatigue Life Testing Machine for Slewing Bearing Based on LabVIEW

Development of Automatic Control System for Disk Low Cycle Fatigue Test Rig

The Design of Characteristic Testing System for GMA Based on LabVIEW

Test System on Thermal Deformation of Headstock in CA6140 Lathe

Study of Automatic Dynamic Balancing System for Engine Crankshaft

Development of Engine Connecting Rod Tension and Compression Fatigue Simulation Test Rig

Study of engine connecting rod fatigue test system based on NI CompactRIO platform

Design and Implementation of Testing Device for Damping Oil Bulk Modulus and Fatigue Characteristic

Study for Vibration Measurement and Failure Diagnostics System for CNC Milling Machines Based on LabVIEW

Study on Test Management and Data Analysis Method of the Crankshaft Fatigue Test

Repetitive Control for the Improvement of Pressure Tracking in Fatigue Test Machine

On-line Testing System for Fatigue Spectrum Load of Structure Materials