Abstract:One of the concerns in the process of measuring laser radar cross-section (LRCS) using optical measurement methods is the aero-optical effect around a high-speed flow field. In this paper, a computational model for LRCS considering supersonic flow in a non-homogeneous medium is presented. First, by taking a typical 15 degrees half-cone blunt cone as the research object, based on CFD calculation, the flow field distribution of the non-uniform medium around the high-speed vehicle is obtained. The ray-tracing method is used to calculate the light transmission in an aero-optical environment. An LRCS approach for arbitrarily complex targets in the aerooptical environment is then proposed, and the method is verified by analytical and numerical methods. Finally, the effects of incoming density, incoming Mach number, and material bidirectional reflectance distribution function (BRDF) parameters on LRCS measurements are investigated, and the errors caused by the steady aero-optical environment are analyzed. The results show that the maximum relative error of the measurement caused by the aero-optical environment in the direction of the shock-wave layer observation is significant when the Fresnel function approximation exponential function parameter is too large or when the root mean square (RMS) of the surface slope is too small in the BRDF parameters of the material. The influence of the aero-optical environmental flow field on the LRCS is characterized by a directional and regional distribution, determined by the incoming Mach number and shock-wave angle, with the influence of the incident flow density on the regional distribution being weakly correlated. The proposed method and calculation results are useful for the simulation, analysis, and calibration of LRCS measurements in complex aero-optical environments.

Bias Errors Induced by Cross-Talk in Two-Phase Flow Measurements

Quantification of the bias error induced by velocity gradients

Bias Errors Induced by Concentration Gradient in Sediment-Laden Flow Measurement with Ptv

Bias Error Induced by Particle Tailing in DPIV Measurement

Bias Error Induced by Concentration Gradients in the Measurement of Sediment-Laden Flows

Error Propagation in the Procedure of Pressure Reconstruction Based on Piv Data

Bias error in measurement of complex flow regime with ultrasonic flowmeter

Uncertainties in Measurements of Bubbly Flows Using Phase-Detection Probes

Measurement error of tracer-based velocimetry in single-phase turbulent flows with inhomogeneous refractive indices

Best practices for velocity estimations in highly aerated flows with dual-tip phase-detection probes

Measurement of Two-Phase Velocities in Bubble Flows Using Laser Doppler Velocimetry

Measuring the Uncertainty of Gas-liquid Mixed Flows Using Vortex Flowmeter

Correction of velocity estimation bias caused by phase‐shift beamforming in acoustic Doppler velocity logs

[The Software Method for Cross-Talk Correction in Ultrasound Doppler Blood Flow Measurement].

Research on the inherent error of ultrasonic flowmeter in non-ideal hydrogen flow fields

Numerical analyses and experimental verification on multiphase flow measurements using a gamma ray densitometer with blind tee mixing

MEASUREMENT OF PARTICLE VELOCITY IN TWO-PHASE FLOW BY OPTICAL CROSS-CORRELATION METHOD

Study on the measurement of in-plane displacement of solid surfaces by laser Doppler velocimetry

Evaluating Uncertainties of Phase Velocity Measurements from Cross-Correlations of Ambient Seismic Noise

Numerical Approaches and Analysis of Optical Measurements of Laser Radar Cross-Sections Affected by Aero-Optical Transmission

Common-midpoint Two-Station Analysis of Estimating Phase Velocity Using High-Frequency Ambient Noise