Treatment of Simulated Brominated Butyl Rubber Wastewater by Bipolar Membrane Electrodialysis

Yanxin Wei,Yaoming Wang,Xu Zhang,Tongwen Xu

DOI: https://doi.org/10.1016/j.seppur.2011.04.003

IF: 8.6

2011-01-01

Separation and Purification Technology

Abstract:A large amount of wastewaters containing sodium bromide (NaBr) is usually generated during the production of brominated butyl rubber; it can cause contamination of the environment. In this study, a method was reported to regenerate hydrobromic acid (HBr) and sodium hydroxide (NaOH) from a simulated NaBr wastewater by bipolar membrane electrodialysis (BMED). Sodium hydroxide may be recycled in the neutralization washing process of preparing the brominated butyl rubber. The effects of operation parameters, such as sodium bromide concentration, current density, and initial acid and base concentrations, on regeneration were analyzed, on the basis of proper energy consumption and current efficiency. The results indicated that a low energy consumption and a high current efficiency were achieved when the concentration of sodium bromide was in the range of 11,000–16,000mg/L with both the initial concentration of the acid and base at about 0.10mol/L. Additionally, it was also demonstrated that a high current density applied to the BMED stack usually resulted in both higher energy consumption and current efficiency. Finally, a discharged NaBr concentration of 133.9mg/L, which was far below the discharge standard of water pollutants for industry, could be obtained from the initial concentration of 16,000mg/L after the operation of BMED process for 3.5h. Therefore, this process cannot only achieve the elimination of environmental pollution, but also the recycling of resources.