Abstract:Crack behavior of aluminum alloy 2A12-T4 is investigated experimentally and numerically using cruciform specimens subjected to in-plane biaxial loadings applied in horizontal (x axis) and vertical (y axis) directions. Different cruciform configuration plans, with variant sizes of slots in loading arms and different transitional fillet radius between adjacent arms, are analyzed by means of FEM to confirm a final specimen geometry with relative uniform stress distribution in its central area. The tests for fatigue crack growth behavior under cyclic biaxial sinusoidal loadings with phase differences of 0 degrees or 60 degrees between two orthogonal fatigue loads are conducted by using a biaxial fatigue test system. The biaxial load ratio, P-max(x)/P-max(y), varies from -0.5 to 1.0. Initial central cracks are inclining in angles of 0 degrees, 45 degrees and 60 degrees to x-axis. Crack growth path and lives are obtained. It is observed that the crack growth behavior under biaxial loading differs from that with only uniaxial loading. A widely accepted fatigue crack growth model, which combines Paris equation, maximum tangential stress (MTS) criterion and an equivalent stress intensity factor (SIF) proposed by Tanaka, is used for mixed mode-I/II crack subjected biaxial loading. The combined model is evaluated by the SIFs analysis based on analytical and numerical solution. The mixed mode SIFs are calculated based on finite element analysis with mesh updating. The simulated crack growth path and growth lives correlate well with the experiments in most cases. Both the experiments and the simulations demonstrate that the tensile load parallel to crack path behaves as the retarder to the crack growth, and the compressive load parallel to crack path behaves as the promoter to the crack growth. It is found that equivalent SIF used in the model overestimates the effect of mode II SIF on the fatigue crack growth rate by Paris equation. It is questionable to use the combined model for the cases with asynchronous biaxial loadings or those leading to crack surface contact.

Plane Stress Steady Crack Growth in a Power-Law Hardening Material

Finite element analysis on plane stress crack growth in a power-law hardening material

Plane strain deformation near a crack tip in a power-law hardening material

Fatigue Crack Behaviors under Asynchronous Biaxial Loading

Plane Stress Crack Growing Steadily in Metal Foams

A Study of the Numerical Simulation Technique for Fatigue Crack Closure

A computational approach to ductile crack growth under large scale yielding conditions

A Plastic Fracture Mechanics Model for Characterization of Multiaxial Low-Cycle Fatigue

Semi-analytical expressions to describe stress fields near the tip of Mode-I crack under plane-strain conditions

An Incremental Analysis of Plane Strain Fully Plastic Crack Growth in Strain-Hardening Materials under Extension

Stress Evolution of Rock-Like Specimens Containing a Single Fracture Under Uniaxial Loading: a Numerical Study Based on Particle Flow Code

Stress, deformation and damage fields near the tip of a crack in a damaged nonlinear material

FEM Solutions for Plane Stress Mode-I and Mode-Ii Cracks in Strain Gradient Plasticity

Fracture of A Thin Power-Law Nonlinear Material with A Crack Using the Dcb Model

Finite element solutions for plane strain mode I crack with strain gradient effects

Mode I Crack Tip Field with Strain Gradient Effects

Fatigue Crack-Closure Analytical Model For Considering Thickness And Hardening Effects

Steady-State Crack Growth and Fracture Work Based on the Theory of Mechanism-Based Strain Gradient Plasticity

In-situ observation of strain evolution and ratchetting of growing fatigue cracks

Crack-tip Constraint and S Stable Growth of Crack in Plane Stress Case

Investigation of small fatigue cracks—I. Plastic deformation associated with small fatigue cracks